Lofrans THETIS 5003 handleiding
Handleiding
Je bekijkt pagina 6 van 60
THETIS 5003
6
If possible mount the connector in a dry place so the rear part of the plug must be protected from contact with water or moisture.
The wires must have a minimum cross section size of 1.5 mm². Install a 5 A (ampere) fast safety fuse on the positive(+) wire of the battery.
Do not use the voltage generated by the engine battery set to provide power.
Series resistor recommended for >5m sensor cable length
The instrument complies with EMC standards and must be positioned at a distance of:
- 30 cm (~1 Ft) from the compass; -50 cm (~1.5 Ft) from radio equipment;
- 2 metres (~6.5 Ft) from radio transmitter equipment; -2 metres (~6.5 Ft) from the radar beam.
Secure the hand held control in place with the cradle provided, tightening the two screws using a cross screwdriver.
3.3 Installing the chain counter
The chain counter must be positioned so that the display will be easy to read. It should not be exposed to direct sunlight. For mounting
the female connector, drill on the dashboard one hole of 20 mm (~13/16”) and secure the female plug with the back locking nut (Fig. A)
to dashboard with a thickness not exceeding 10mm.
Put the gasket between the rear part of the plug and the dashboard.
For instructions on making electrical connections, see the wiring diagram with the table below (Fig.B).
6-POLE REAR CONNECTOR
PIN SIGNAL
1 - battery
2 + battery
3 DOWN command
4 UP command
5 Magnetic sensor
6 Buzzer
(Fig. B)
(Fig. A)
20mm
Bekijk gratis de handleiding van Lofrans THETIS 5003, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | THETIS 5003 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7542 MB |
