Lofrans THETIS 5003 handleiding
Handleiding
Je bekijkt pagina 7 van 60
www.lofrans.com
7
Hold down the (ON) key for six seconds to
access the instrument setting menu. The following
page will appear on the display:
Use the (DOWN) and (UP) keys to
move around the menu options.
Once you are positioned on the item to be modied press the (ON) key to conrm your choice.
Use the (DOWN) or (UP) keys to move from one parameter to another.
Once one is positioned on the parameter press the (ON) key to enable modication.
According to the type of parameter, using the (DOWN) and (UP) keys it is possible to
reduce/increase the value of the same or disable/enable the function.
Once the modication has been performed, press the (ON) key to conrm.
Using the (DOWN) key go to the Exit option and press the (ON) key again to return to
the setting menu. The same procedure must be used to return to the main page.
4.2 Chain counter setting menu
Once the initialisation procedure is complete, the main page will appear.
Where:
STATUS: indicates the status of the instrument and any failure.
SPEED’: indicates the chain speed during hoisting or lowering in meters per minute or feet per minute.
COUNT: indicates the measurement of the chain lowered (in metres or feet).
MONITORING: indicates the power supply voltage of the instrument and the power supply voltage of the boat.
ICONS: this is the part of the display bearing the icons that indicate the hoisting or casting of the anchor and any failure.
When the instrument is turned on for the rst time, it will set up as programmed in the factory (see table).
Menu
Measure
Alarms &Function
Settings
Language
S ensor Calibration
V=11.6 Vdc
UK
4.1 Starting up
The chain counter features a graphic display and three keys: (ON), (UP) and (DOWN). There
is also a buzzer that indicates the pressing of the keys or attracts the user’s attention in particular conditions
(alarm triggering). The ON key switches on the display and enables the other two keys. It must be used to
access the parameter setting menus. For selecting the parameters to be modied and to conrm the values
set. The display backlight will switch off 30 seconds after the last command given (adjustable default time – see
“Light Time”).
The UP key commands the hoisting of the anchor and the DOWN key casts it. When the key is released, the
action is stopped. During parameter setting, the two keys allow the User to move around the menu and vary
parameter values.
When switched on, the instrument will make a beep and the following page will appear for a few seconds:
4 MENU
Bekijk gratis de handleiding van Lofrans THETIS 5003, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lofrans |
| Model | THETIS 5003 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7542 MB |
