Livarno Lux IAN 354287 handleiding
Handleiding
Je bekijkt pagina 32 van 42
32 GB/MT
Initial use / Maintenance and cleaning Safety / Preparation / Prior to installation / Initial use
Prior to installation, remove the fuse or switch
off the circuit breaker (0 setting) in the fuse box.
Prior to installation verify the mains voltage on
site corresponds with the operating voltage
required for the light (see “Technical data“).
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the light on a wet or conductive
substrate!
Prevent fire and
injury hazards
RISK OF INJURY!
Check each light bulb and the lampshade for
damage immediately after unpacking.
Do not assemble the light if the light bulbs
and / or lampshade are defective. In this case,
contact the service centre for a replacement.
Do not look directly into the light source (light
bulb, LED etc.).
Do not use optical instruments to look at the
light source (e. g. magnifying glass).
This lights’s illuminant is not replaceable; if the
illuminant has reached the end of its service
life, the whole light must be replaced.
This light is not suitable for external
dimmers or electronic switches.
Safe working
Mount the light so that it is protected from
moisture and dirt.
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never install the light if you are having difficulty
concentrating or do not feel well.
Preparation
Required tools and material
The tools and materials specified are not included.
This information and these values are non-binding
and are only provided as a reference. The nature
of the material is determined by the individual local
conditions.
- Pencil / making tool
- 2-pole circuit tester
- Screwdriver
- Electric drill
- Bit (approx. Ø 6 mm)
- Side cutting pliers
- Ladder
Prior to installation
Important: The electrical connection must be
established by a qualified electrician or a person
trained to perform electrical installations. This per-
son must be familiar with the properties of the light
and the connection regulations.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the light
itself, before you install it.
Before installation ensure that the circuit, to which
the light will be connected, is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box (0 position).
Use a 2-pole voltage tester to verify cables are
not live.
Initial use
Installing the light
Model 14144406L / 14144408L:
Before installing the light, remove the fuse or
switch off the circuit breaker (
0 setting) in the
fuse box.
Bekijk gratis de handleiding van Livarno Lux IAN 354287, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | IAN 354287 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3790 MB |
