Livarno Lux IAN 331005 handleiding
Handleiding
Je bekijkt pagina 8 van 18
8 GB/IE/NI
CAUTION! EXPLOSION HAZ-
ARD! Never throw rechargeable
batteries into fire or water.
Expired or drained rechargeable batteries may
leak chemicals which will damage the product.
Remove, therefore, the rechargeable battery
when the lamp is not required for any length of
time.
WEAR PROTECTIVE GLOVES!
Leaked or damaged rechargeable
batteries could cause chemical
burns on contact with the skin; you should
therefore wear suitable protective gloves at all
times if such an event occurs.
Only use rechargeable batteries of the correct
size and and the recommended type (see sec-
tion ”Technical data”).
Ensure correct polarity, indicated in the battery
compartment.
Functionality
The solar cell built into the product converts sunlight
into electricity and stores it in a Ni-MH rechargea-
ble battery. The light switches on at dusk. The built-
in LED is an energy-saving light bulb with a very
long life. The light duration depends on the amount
of sunlight, the angle at which light hits the solar panel,
and the temperature (the battery capacity varies by
temperature). A vertical angle of light at temperatures
above the freezing point is ideal. The rechargeable
battery will only achieve its maximum capacity af-
ter several charging and discharging cycles.
Initial use
Mounting the light
WEAR PROTECTIVE GLOVES!
Wear protective gloves when as-
sembling and setting up the light!
Pull the solar cell housing
2
including
lampshade
1
out of the lamp body
3
.
Push the ground stake
4
out of the adapter
5
and into the lamp body
3
.
Push the ground stake
4
into the ground in the
desired location and attach the lamp body
3
.
Set the ON/OFF switch
7
to the position
marked “ON“ to allow the product to switch
on in the dark.
Reattach the solar cell housing
2
with lamp
shade
1
to the lamp body
3
. Your solar
light is now ready to use.
Installing the light
Push the ground stake
4
far enough into the
ground (lawn, flower bed) so it is firmly posi-
tioned upright in the ground. Then attach the
assembled solar light to the ground spike
4
.
Make sure it is firmly positioned. Do not use
force when assembling or setting up the prod-
uct, e.g. hammer blows. This will damage the
product. In order to achieve the best result, set
the solar garden lamp up in a place where the
solar cell will get direct sunlight for as long as
possible.
Make sure the solar cell is not impacted by
other light sources, e.g. yard or
street lighting,
or the light will not
switch on at dusk.
The light will automatically switch on in low
light and switch off in normal daylight.
Replacing the
rechargeable battery
The batteries should be replaced every 12 months
to ensure optimum performance.
Remove the lampshade
1
from the lamp
body
3
.
Pull the solar cell housing
2
out of the lamp-
shade
1
.
Switch off the light using the ON/OFF switch
7
by setting the switch to the “OFF“ position.
Remove the fastening screws
8
using a small
cross-tip screwdriver. Then open the battery
Bekijk gratis de handleiding van Livarno Lux IAN 331005, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | IAN 331005 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1881 MB |
