Livarno Lux IAN 283481 handleiding
Handleiding
Je bekijkt pagina 9 van 37
9 GB/IE/NI
Initial use / Installing the … / Switching the LED … / Installing / replacing the batterySafety / Initial use
Choose between a long connector or a direct
connector.
When connecting, the LED strip
1
pole mar-
ked “+“ must be on the plug end of the plug-in
connector
2
marked with the arrow. Ensure the
correct polarity (+ G R B <–> + G R B) here.
Verify it is seated correctly.
Shortening the LED strip
The LED strip
1
may be trimmed to size.
DANGER TO LIFE BY
ELECTRIC SHOCK!
Disconnect the lights from the power supply be-
fore performing any work on the LED strip
1
.
To do this, remove the USB plug
3
from the
USB connector.
Choose the desired LED strip length.
Note: Ensure that you cut the LED strip
1
at
the right place.
The cutting point is the exact middle between
the positive and negative poles and is always
marked with a white line.
Shorten the LED strip
1
using a pair of scissors.
Be sure to cover the open end of the LED strip
1
with the adhesive strip before use.
CAUTION: After shortening the LED strip
1
it may no longer be connected together.
Installing the LED strip
Note: Ensure that the installation area is clean,
grease-free and dry. Otherwise the functionality of
the adhesive strip may be impaired.
Note: Ensure that a USB connector is located in
close proximity to the installation area.
Choose a suitable installation area.
Remove the protective foil from the reverse side
of the LED strip
1
.
Remove the protective foil from the reverse side
of the cable hold
5
.
Stick the cable holder in the directed location.
Stick the infrared diode into the cable holder.
Stick the LED strip
1
with the adhesive strip
onto the installation area and press it on firmly.
Insert the USB plug
3
into the USB connector.
Your light is now ready to use.
Switching the LED strip on / off
with the remote control
Note: Position the infrared diode for the receiver
so it can be controlled with the remote control
4
without obstructions.
Note: The range of the remote control is approx. 4 m.
Remove the safety strip in the battery compart-
ment before switching the light on.
Press the ON button to switch the lamp on.
Press the OFF button to switch the light off.
Choose from the following functions:
Button
: brighter
Button
: dim
5 x R: selects the desired colour
5 x G: selects the desired colour
5 x B: selects the desired colour
1 x W: selects the desired colour
FLASH button: rapid colour change
STROBE button: slow colour change
FADE button: slow, flowing colour change
SMOOTH button: flowing colour change
Installing / replacing the
battery (remote control)
Note: Please observe the imprint on the back of
the remote control
4
.
Push in the release lever and pull out the battery
compartment. Remove the spent battery, if ne-
cessary. Insert a new battery in the battery com-
partment. Only use type CR2025 3 V batteries.
Note: Be sure to correctly insert the batteries
(polarity). This is indicated on the remote con-
trol
4
.
Bekijk gratis de handleiding van Livarno Lux IAN 283481, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | IAN 283481 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2965 MB |
