Livarno Lux 14166602L handleiding
Handleiding
Je bekijkt pagina 16 van 117
Avoid the risk of fatal injury from
electric shock
■
Ensure that a qualified electrician, or a person
trained to carry out electrical installations, performs
the electrical installation.
■ Always check the light, power supply, and mains
cable for damage before plugging it in. Never use
the light if it shows any signs of damage.
WARNING!
A damaged mains cable indicates a life-threatening
danger due to electric shock. In the event of damage,
repairs or other problems with the light please contact
the service centre or a qualified electrician.
■ Prior to installation, remove the fuse or switch off the
circuit breaker (0 setting) in the fuse box.
■ Prior to installation verify the mains voltage on site
corresponds with the operating voltage required for
the light (see “Technical data“).
■
Never open any of the components of the electrical
equipment or insert any objects into the same
components. This will pose a risk of fatal injury from
electric shock.
■ Do not install the light on a wet or conductive
substrate!
Prevent fire and injury hazards
RISK OF INJURY!
Check the light for damage immediately after
unpacking.
■ Do not mount the light with defective lamps and / or
lamp lenses. In this case contact the service centre
for a replacement.
■ Do not look directly into the light source (light bulb,
LED etc.).
■ Do not use optical instruments to look at the light.
■ The light’s illuminant is not replaceable. The entire
light needs to be replaced if the illuminant reaches
the end of its service life.
■ This light is not suitable for external
dimmers or electronic switches.
Safe working
■ Mount the light so that it is protected from moisture
and dirt.
■ Carefully prepare for assembly and allow yourself
adequate time. Organise all parts and any neces
sary additional tools or materials before starting so
they are easy to reach.
■ Always be attentive! Always pay attention to what
you are doing and use common sense. Never install
the light if you are having difficulty concentrating or
do not feel well.
● Preparation
● Required tools and material
The tools and materials specified are not included.This
information and these values are non-bindingand are
only provided as a reference.The nature of the material
is determined by theindividual local conditions.
- Pencil / making tool
-
2-pole voltage tester
- Screwdriver
- Electric drill
- Bit (ø 6 mm)
- Side cutting pliers
- Ladder
● Prior to installation
Important: The electrical connection must be estab
lished by a qualified electrician or a person trained to
perform electrical installations. This person must be
familiar with the properties of the light and the connec
tion regulations.
□ Be sure to pay attention to the type of the supporting
surface, as the enclosed fastening material is not
suitable for all types of walls. Inquire at the hard
ware store about the screws and wall plugs suitable
for your type of supporting surface. The manufac
turer accepts no liability for improper wall to wall
plug connection and any damage caused as a
result.
□
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the light
itself, before you install it.Familiarise yourself with all
16 GB/IE
Safety / Preparation / Prior to installation
Bekijk gratis de handleiding van Livarno Lux 14166602L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Livarno Lux |
| Model | 14166602L |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11248 MB |
