Lincoln Electric RealWeld handleiding
Handleiding
Je bekijkt pagina 24 van 52
B-8
OPERATION (INSTRUCTOR MODE)REALWELD
®
TRAINER
JIG PLATFORM SETUP
The jig platform can be setup in three different positions.
Position 1 - Flat orientation (position 1). See Figure B.32.
Position 2 - Horizontal and Overhead orientation (position 2). See
Figure B.33.
Position 3 - Vertical orientation (position 3). See Figure B.34.
CALIBRATION PROCEDURES
JIG CALIBRATION
NOTE: Must be logged in as instructor to perform calibration.
The jig calibration procedure helps ensure that the cameras are
always reading the exact location of the jig platform. It is necessary
to go through the jig calibration procedure in three different situations.
Situation 1 - When the system is first installed.
Situation 2 - If the user is seeing consistent erroneous data that
relates to position such as proximity. If the output values seem to be
incorrect, the jig may need to be re-calibrated.
Situation 3 - Every 30 days.
1. Before beginning the calibration procedure, remove the jig and any
clamps (including the ground clamp) from the jig platform.
2. Open all camera lenses.
3. Select the ‘Jig Calibration’ icon on the left of the screen to begin
the calibration procedure. See Figure B.35.
4. Select the ‘Position 1’ icon on the left side of the screen. See
Figure B.35.
5. Select the ‘Calibrate’ icon on the left side of the screen. This will
bring up the ‘Calibrate Jig’ window. See Figure B.36.
Figure B.32 – Position 1
Figure B.33 – Position 2
Figure B.34 – Position 3
Figure B.35 – Tool calibration
Figure B.36 – Calibrate jig
Bekijk gratis de handleiding van Lincoln Electric RealWeld, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lincoln Electric |
| Model | RealWeld |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 13902 MB |
