Liebherr SWNsdh 5264 Prime handleiding

24 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 21 van 24
q
The rear of appliance is accessible so that you can
connect the appliance to the drinking water supply.
q
The supplied hose is used. Old hoses have been disposed
of.*
q
The hose connector contains a filter with a seal.*
q
There is a tap between the hose line and the domestic
water connection so that you can turn off the water
supply if necessary.*
q
The tap is not directly behind the appliance and is easily
accessible. This way, you can push the appliance as close
as possible to the wall and can quickly turn off the tap if
necessary.*
WARNING
Risk of electric shock from water!
u
Before connecting to the water pipe: Disconnect the
appliance from the mains.
u
Before connecting to water supply lines: Shut off the
water supply.
u
Make sure that only qualified personnel connect the
device to the drinking water supply.
WARNING
Risk of poisoning due to contaminated water!
u
Only connect to the drinking water supply.
15.1 Connecting the hose*
Fig.54
(1)
Solenoid valve: The
solenoid valve is
located at the bottom
rear of the appliance.
It has an R3/4 connec‐
tion thread.*
(5) Closure cap*
(2) Cover* (6) Hose*
(3) Angled hose end* (7) Straight hose end*
(4) Nut* (8) Tap*
NOTICE
Risk of damage from incorrect installation!
u
Do not damage or kink the hose.
u
Do not damage or kink the hose when setting up the
appliance.
Connecting the hose to the appliance:
u
Pull off the cover(2).
u
Push and hold the nut (4) all the way over the angled
hose end(3).
NOTICE
The solenoid valve will not be tight if the thread is damaged!
If the solenoid valve is not tight, water may leak out.
u
Observe the following instructions for fitting the nut on
the solenoid valve.
u
Carefully position and hold the nut (4) on the solenoid
valve(1).
u
Screw the nut(4) onto the thread by hand until it is firmly
in place.
WARNING
Danger of cuts if the tool is broken!*
u
Only use the tool(5) at room temperature.
u
Tighten the nut (4)clockwise with the tool (5) until the
maximum torque is reached and the tool (5) no longer
tightens.*
w
The hose is connected to the appliance.
Connecting the hose to the tap:
u
Screw the nut onto the straight hose end (7) on the
tap(8).
WARNING
Danger of cuts if the tool is broken!*
u
Only use the tool(5) at room temperature.
u
Tighten the nut at the straight hose end (7) clockwise
using the auxiliary tool (5) until the maximum torque is
reached and the auxiliary tool(5) seizes.*
u
Hook the lug(6) into the tool(5).*
u
Fasten the lug(6) to keep it on the hose.*
w
The hose is connected to the tap.
15.2 Checking the water system
Before you completely install the appliance, Liebherr recom‐
mends checking the water system for leaks.
u
Put in the InfinitySpring water tank.
u
Put in the InfinitySpring water filter. (see 16 Water filter*)
*
u
Slowly turn on the tap.*
u
Check the hose, water feed and connections for leaks.
w
The water system has now been checked for leaks.
w
The water system is not leaking: You can install up the
appliance completely.
Note
InfinitySpring: Before the first use, you must put the Infin‐
itySpring into operation. To do this you must bleed and
clean the water system. (see Quick Start Guide or operating
instructions)
IceMaker: Before the first use, you must clean the IceMaker.
(see Quick Start Guide or operating instructions)
16 Water filter*
Depending on your model, the water filter is behind the
lowest drawer in the fridge or BioFresh compartment.*
It filters out deposits in the water and reduces the taste of
chlorine.
q
Replace the water filter at least every 6 months, or if
there is a significant reduction in the flow rate.
q
The water filter contains carbon and can be disposed of
with the regular household waste.
Water filter*
* Depending on model and options 21

Bekijk gratis de handleiding van Liebherr SWNsdh 5264 Prime, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkLiebherr
ModelSWNsdh 5264 Prime
CategorieKoelkast
TaalNederlands
Grootte6456 MB