Handleiding
Je bekijkt pagina 6 van 20
6
ELECTRICAL SAFETY
Ensure that you check the equipment thoroughly to ensure it is safe and t for purpose before
each use. It is important that you inspect all plugs, sockets, power cables and electrical ttings
for wear and damage and repair or replace any defective components. The risk of electric shock
can be minimised by the correct use of the appropriate electrical safety devices.
• We recommend that you t a Residual Current Circuit Breaker (RCCB) in the main distribution board and that
a Residual Current Device (RCD) is used when operating this equipment.
• Check that all equipment cables are secure, correctly insulated, free from damage, and protected against
short circuit and overload before connecting to the power supply. Do not use worn or damaged cables, plugs,
sockets or other ttings.
• Ensure that the power supply matches voltage requirements specied on the
equipment and that the plug is wired correctly and tted with the correct fuse.
• If the electrical fuse blows, ensure it is replaced by an identical type of fuse
with the same rating.
• Never pull or manoeuvre this equipment into position using the power cable.
• Ensure the power cable is kept away from heat, oil and sharp edges.
• We recommend that the equipment is connected directly to the power supply
without the use of extension leads as the resulting voltage drop can reduce
motor performance.
• Always disconnect the equipment from the power source before servicing,
inspecting, maintaining, cleaning, replacing or checking any parts.
WORK AREA SAFETY
• Always ensure a sucient working area, that is clean and tidy, and free access to the machine and peripheral
devices.
• Ensure sucient lighting is available in the working area which will not create shadows or cause a stroboscopic
eect.
• Disconnect the heater from the mains supply when not in use.
• Avoid unintentional starting: Make sure the switch is in the “OFF” position before connecting the heater to the
mains supply.
• Never carry the heater by the mains lead or pull it to remove the plug from the mains socket. Keep the mains lead
away from heat, oil and sharp edges.
• If the mains lead is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualied
person in order to avoid unwanted hazards.
• Do not expose the heater to water spray, rain, dripping water or moisture of any kind.
• Do not touch the heater outlet or any internal parts when rst switched o as these can be hot and will take time
to cool.
• Ensure that the heater is correctly turned o when not in use and stored in a safe, dry area, out of reach of
children.
• Do not unplug the heater to switch it o - always use the ON / OFF switch on the control panel and allow the
cooling fan to run and automatically stop (after around 3 minutes?) before disconnecting from the mains supply.
WARNING: Do not use the heater near ammable material, liquids, solids, gases or compressed gas cylinders.
Do not direct the front of the heater towards any combustible materials (e.g. wooden items, cloth, plastics, paper).
LAVOR - IRH-70
USER MANUAL
70,000BTU - Industrial Radiant Heater
www.lavorwash.com.au
Bekijk gratis de handleiding van Lavor IRH-70, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lavor |
| Model | IRH-70 |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 3752 MB |
