Handleiding
Je bekijkt pagina 7 van 20
7
ASSEMBLY INSTRUCTIONS
FITTING THE HANDLE
1. Attach the handle by lining up the
holes in the handle with the holes on the
upper shell / housing of heater (see Fig.1).
2. Insert the screws and tighten until secure
FITTING THE STAND
1. Line up the holes on the stand with the
holes on the fuel tank of the heater as
shown in (see Fig.2).
2. Fit screws through the holes and secure
in place by tting and tightening the nuts.
PLEASE NOTE: When using the heater for the rst time, you may notice a slight emission of smoke, or a slight
burning smell. This is normal and will stop after a short time. Parts of the heater were coated with protection oil
during production. The smoke / smell is caused by any small residue of this oil.
CLEARANCE REQUIREMENTS
Always provide adequate space around the heater as shown in the diagram and table in (Fig.3) below:
Fig. 1 Fig. 2
Fig. 3
Clearance:
Top: Top - 150cm
Sides: Sides - 150cm
Rear: Rear - 150cm
Front: Front - 300cm
150cm
150cm
150cm
150cm
300cm
LAVOR - IRH-70
USER MANUAL
70,000BTU - Industrial Radiant Heater
www.lavorwash.com.au
Bekijk gratis de handleiding van Lavor IRH-70, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lavor |
| Model | IRH-70 |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 3752 MB |
