Lavex 842CD123ST12 handleiding
Handleiding
Je bekijkt pagina 9 van 12
(16) Lavex 12-Gallon, 500 PSI Carpet Extractor Lavex 12-Gallon, 500 PSI Carpet Extractor (9)
5.0 Maintenance Continued
• Do not allow water to remain in the tanks after use.
• Lubricate all quick disconnects with WD-40 or similar lubricant.
• Clean vacuum oat assembly screen.
Operation Interval
Clean Fresh Water Tank Filter Daily - After Each Job
Clean Vacuum Assembly Screen Daily - After Each Job
Rinse Out Recovery Tank Daily
Clean Pump Inlet Filter Weekly - As Needed
Clean Pump In-Line Pump Filter (H20 Filter) Weekly - As Needed
Clean Dump Valve Weekly - As Needed
WD-40 Vacuum Motors Weekly - As Needed
Prevent Mineral Deposit Build-Up Every Two Weeks
5.1 Clean Vacuum Float Assembly Screen
Inside the recovery tank, on top of the stand pipe, is the vacuum oat assembly. It
functions to prevent debris and water from being sucked into the vacuum motors.
Operating the equipment without the oat assembly or with a poorly maintained
assembly, will greatly decrease the life of the vacuum motor and will VOID your
warranty.
If debris builds up on this lter, it will reduce
the vacuum air ow and may cause a signicant
decrease in the rate of water recovery. If debris
prevents the oat ball from moving or seating inside
the assembly, it may not stop the airow when the
tank lls with water and water will be sucked in the
vacuum and blow out the exhaust.
To clean, twist o the oat assembly from the stand
pipe and clean the screen. Pull bers and lint o and
rinse with clean water. Push the assembly back onto the
stand pipe and replace the recovery tank lid.
This screen should be cleaned daily, especially if the carpet extractor is being operated
in an environment which has an abnormal build-up of lint and debris, such as cleaning
newly installed carpet. Loss of vacuum is most normally associated with lint build-up in
this lter at the top of the vacuum stand pipe.
5.2 Rinse Out Recovery Tank
Build-up of ne silt and debris can damage the auto-dump pump and dump valve. Clean
out the recovery tank on a regular basis to extend the life of these components as well as
keep the tank and machine smelling better.
Vacuum Shut-O Assembly
11.0 Machine Schematic Drawing – No Heater
Bekijk gratis de handleiding van Lavex 842CD123ST12, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lavex |
| Model | 842CD123ST12 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3724 MB |
