Handleiding
Je bekijkt pagina 15 van 24
15
Exclusive to Howdens
Installation Instructions
Injector
See gas type table on page 19 for
corresponding injector types.
Gas connection (continued)
Adapting the hob to different types of gas
Regulating the minimum flame
1
Remove the pan supports and burner crowns and caps.
2
Insert an hexagonal spanner (7mm) into the burner support.
Unscrew the injector and replace it with one suitable for the gas to be used.
To replace the injectors with injectors of a size corresponding to the type of gas to be used, see the gas
type table on page 19, and carry out the following instructions.
NOTE: If the gas type of the unit is changed, then the rating plate
that shows the gas type of the unit must also be changed.
After lighting the burners, turn the control knob
to the minimum setting, then remove the knob.
(This can be easily done by pulling vertically
using gentle pressure).
1
When the gas supply available is LPG
If using LPG, this screw must be turned clockwise to
the end stop to set the idle flame.
When you have carried out the new gas regulation,
replace the old gas rating plate on the appliance
with one (supplied with the hob), suitable for the
type of gas for which it has been regulated.
3
Finally, replace the control knob.
Using a small "terminal" type screwdriver, the
regulating screw can be adjusted as shown.
2
• Turning the screw clockwise
reduces the gas flow.
• Turning the screw anti-clockwise
increases the gas flow.
Adjust to obtain a flame of approximately
3 to 4mm in length.
Bekijk gratis de handleiding van Lamona LAM1114, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Lamona |
| Model | LAM1114 |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 7886 MB |