Handleiding
Je bekijkt pagina 11 van 25
KIBXX II/KWIBXX II ICEBERG SERIES SYSTEMS KWIKOOL
11
1. ON/OFF Button - A short press on this button engages or shuts down the Iceberg system. All
settings selected are stored in the microprocessor board even if the power is lost, including the
ON/OFF selection. Refer to the Troubleshooting Guide section of this manual if the Iceberg is giving
an alarm after selecting ON.
2. MODE Button – A short press on the icon selects the operator’s choice of operations.
a) COOL for cooling with compressor operation. Flashes when the compressor is running. Will not
flash when the room temperature is equal to or lower than the set temperature or the system is
timing out, signified by F or C flashing next to the room temperature.
b) FAN for air supply circulation without compressor operation.
3. FAN Button – A short press on the FAN button has different operations depending on the model.
a) Single Speed Models – KWIB & KIB2411 II, KWIB & KIB6043 II, KWIB & KIB12023 II, KWIB
and KIB12043 II.
1) Models 2411 and 6043 - A short press on the FAN button in COOL mode cycles the supply
air fan between AUTO FAN and fan on. When the system is in AUTO FAN, the supply air
fan only operates when the compressor is running and the words AUTO FAN display above
the MODE button.
2) Models 2411 and 6043 - A second short press on the FAN button operates the fan
continuously as long as the Iceberg Series System is in COOL and in the ON position. The
display above the MODE button will be blank when this function is selected.
3) Models 12023 II and 12043 II - These models are 2 stage systems and have a fan speed
for each stage. This feature is not user settable. This system always starts in first stage fan
speed (low) in COOL or FAN. Second stage fan speed (high) only operates in COOL when
the second stage compressor is running.
b) Three Speed Models – (All other models NOT listed above.) The Supply Air FAN button has
several functions.
1) A short press on the FAN button in COOL mode will cycle through the fan speeds. Each
press cycles the fan from low to medium to high, signified by an ascending set of arrows
above the FAN button.
2) A short press on the FAN button after high speed appears and the word AUTO appears
above the speed indicator. In AUTO, the fan speed is automatically adjusted based on
demand, the currently operating fan speed is displayed.
3) The second function is to change from constant fan, signified by a blank screen above
MODE, to AUTO FAN.
4) When in AUTO FAN; the Supply Air only operates when the compressor is running. To
select this function, press and hold the FAN button until the indicator above the MODE
button reads AUTO FAN.
5) When in FAN mode, AUTO FAN is not available; however, operators are able to adjust the
speed of the fan with each short press of the FAN button. If the Iceberg Series System was
set to AUTO FAN before changing the mode to FAN, AUTO FAN will return when the
Iceberg Series System is set back to COOL. Factory default is FAN (constant fan) and is the
best choice for electronic equipment.
4. Up (+) and Down (-) Selector Buttons - Raises or lowers the desired set temperature.
Bekijk gratis de handleiding van KwiKool KIB3021-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | KwiKool |
| Model | KIB3021-2 |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 3684 MB |
