Handleiding
Je bekijkt pagina 12 van 25
KWIKOOL KIBXX II/KWIBXX II ICEBERG SERIES SYSTEMS
12
a) When changing the set point using a short press on the button, the word SET will appear on the
display and the current set point flashes on and off. The value of the set point is changed 1
degree each time the button is pressed.
b) The adjusted set point flashes on and off 12 times after the last change and then returns to
display the room temperature after about ten seconds.
CAUTION
Lowering or raising the set point will not change the temperature
of the Supply Air. For best results always adjust the set point to a
temperature at which the Iceberg can cycle on and off to avoid
operational issues such as freezing or rapid discharge air fan
cycling
CAUTION
The lowest set point temperature available for the Iceberg is 60
degrees F, and the highest set point is 95 degrees F. The control
will not allow adjustments beyond these ranges. Iceberg systems
are designed to maintain the set point when sized properly.
Constant operation without achieving the set point may shorten
the expected operational life of the system.
C SYSTEM OPERATION
1. Turn On Iceberg System - Pressing the ON/OFF button once on the control touch screen will allow
operation of the Iceberg. The system will operate in the previously chosen MODE, either COOL or
FAN.
2. COOL - If the Iceberg Series Cooler was previously set to the cooling mode, then will be
displayed.
a) If the compressor is running, the on the display will be flashing.
b) If the Iceberg Series System has been sitting for over 2 minutes, this should happen
immediately upon turning the Iceberg Series System on, unless the set point is lower than the
current room temperature. In the latter case, the Iceberg Series System is ready to
automatically turn on once the temperature rises above the set point.
c) If the Iceberg Series System was recently turned off or the Iceberg Series System turned itself
off because it reached the set point, the compressor will not turn on until the system waits for
approximately 2.5 minutes. This prevents the compressor from being damaged due to a
condition called short cycling (of the compressor). The indication that the Iceberg Series System
is in the “time out” condition is that the F (or C) in the display will be flashing.
d) When the compressor starts, the F will stop flashing and the will begin flashing.
Bekijk gratis de handleiding van KwiKool KIB3021-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | KwiKool |
| Model | KIB3021-2 |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 3684 MB |
