Kramer 860 handleiding
Handleiding
Je bekijkt pagina 8 van 55
Kramer Electronics Ltd.
860 – Overview
6
#
Feature
Function
8
ANALYZER /
PATTERN Button
Press to switch the unit between Analyzer Mode (LED=Red) and Pattern
Mode (LED=Blue).
In Analyzer Mode: Press and hold for 2 seconds to force an RX hot-plug.
In Pattern Mode: Press and hold for 2 seconds to turn on/off the AVMute bit
within the output’s General Control Packet (GCP).
Press and hold while powering the unit to perform a factory reset.
9
EDID PATTERN
Button
Press to enable selection of the EDID to use on the HDMI input port. The
▼/▲ buttons illuminate and are used to select the new EDID. The currently
selected EDID is shown on the OLED display. The new EDID automatically
becomes active after selecting it and pausing for 5 seconds.
10 HDCP PATTERN
Button
Press to enable/disable the OSD display of the detected HDCP version
support and handshaking information between the sink and source.
In Analyzer mode the unit is the RX, in Pattern mode the unit is the TX.
In Pattern mode, if HDCP handshaking fails, an error message “HDCP OUT
FAIL” is displayed on the OSD.
11
AUDIO LPCM
Button
Analyzer mode: Press to select which digital audio source pair (0-3) is routed
to the primary stereo channel (LPCM 2.0 and headphone output) for
monitoring. The LED color indicates the selection (Off=SD0, Red=SD1,
Blue=SD2, Purple=SD3).
Pattern mode: Press to switch between LPCM 2.0 (LED=Red), 5.1
(LED=Blue) and 7.1 (LED=Purple) channel test tone output formats. Press
and hold for 2 seconds to allow adjustment of the output volume.
12
HDCP ON/OFF
Button
Press to switch between supported HDCP versions or to disable HDCP. In
Analyzer mode: OFF (LED=Off), HDCP 1.4 (LED=Red), and HDCP 1.4+2.2
(LED=Blue) modes are available for the input port. In Pattern mode: OFF,
HDCP 1.4, and HDCP 2.2 modes are available for the output port.
13
DEEP COLOR
Button
Press repeatedly to switch between the available output color bit depth
options. The button’s LED is colored to indicate the current bit depth: Off=8-
bit, Red=10-bit, Blue=12-bit.
14
COLOR Space
Button
Press repeatedly to switch between the available color space formats. The
button’s LED is colored to indicate the current color space: Red=RGB,
Blue=YCbCr 4:4:4, Purple=YCbCr 4:2:0, Off=YCbCr 4:2:2.
15
OUTPUT FORMAT
Button
Press to switch between DVI (LED=Blue) and HDMI (LED=Red) output
formats. Press and hold the button for 2 seconds to disable/enable video
output completely. The button’s LED turns off when the output is disabled.
Bekijk gratis de handleiding van Kramer 860, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kramer |
| Model | 860 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7508 MB |
