Kogan SmarterHome KASHSAC80TA Handleiding (68 Pagina's)

Handleiding

18

Step 3: Drill Wall Hole

A hole in the wall should be drilled for refrigerant piping, the drainage pipe and connecting

cables.

1. Determine the location of wall hole base on the position of mounting plate.

2. The hole should have a 70mm diameter at least and a small oblique angle to

facilitate drainage.

3. Drill the wall hole with 70mm core drill and with small oblique angle lower than the

indoor end about 5mm to 10mm.

4. Place the wall sleeve and wall sleeve cover (both are optional parts) to protect the

connection parts.

Caution: When drilling the wall hole, ensure to avoid wires, plumbing and other sensitive

components.

Step 4: Connecting Refrigerant Pipe

1. According to the wall hole position, select the appropriate piping mode. There are

three optional piping modes for indoor units (as shown in the illustration on the

next page):

• In Piping Mode 1 or Piping Mode 3, a notch should be made by using scissors

to cut the plastic sheet of piping outlet and cable outlet on the corresponding

side of the indoor unit.

Outdoor

Small oblique

angle

Wall sleeve

(Optional)

Indoor

5-10mm

Wall sleeve Cover

(Optional)

Note: When cutting off the plastic sheet at the outlet, the cut should be trimmed to

smooth.

Bekijk gratis de handleiding van Kogan SmarterHome KASHSAC80TA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.