Kluge KMKD-04M handleiding

Handleiding

123456789101112131415161718192021222324/ 24

Afdrukken

Je bekijkt pagina 19 van 24

18

EN

FILLING THE WATER TANK

1. Make sure that the ice cube maker is unplugged from the mains.

2. Li the lid (3), remove the ice cube bucket (10), and ll the water tank (5) with no more than 1.2 litre

of water at an ambient temperature. Do not spill the water on the housing.

CAUTION! Do not ll the water tank over the max water level. Use clean potable water only.

3. Install the ice cube bucket (10) and make sure that

the level of water in the tank is below the boom

of the ice cube bucket (10).

4. Close the lid (3).

USING THE ICE CUBE MAKER

1. Having properly posioned the ice cube maker and

lled it with water, plug it into the mains. The ice

cube maker POWER indicator (4e) will be ashing.

2. Press the ON/OFF buon (4a) - the ice maker will

start the ice making process and the POWER indi-

cator light (4e) will light up connuously. Use the SELECT buon (4b) to select the size of the ice

cubes you receive:

- (S) - small ice cubes

- (L) - large ice cubes

3. The machine will produce 9 ice cubes every 6-8 minutes depending on the size of the cubes.

However, this me may also vary slightly depending on the ambient temperature and pressure.

Typically, the rst cycle of the device may be slightly longer. If the room temperature is lower than

15°C, it is recommended to choose a small ice cube to prevent the ice from scking together.

4. Inspect the ice cube making process through the viewport (2). When the ice cube bucket (10) is

completely lled with ice cubes, the ICE FULL indicator (4b) will light up. Remove the ice cube

bucket (10), store the ice cubes in a cool place and put the ice cube bucket (10) back in the ice

cube maker. The ice cube maker can be restarted again right away to make more ice cubes. If you

do not remove the ice cubes in me, they will ulmately melt and the water will ow back to the

water tank.

5. If the water tank (5) is empty, the ADD WATER (4c) indicator will light up. Turn o and unplug the

ice cube maker from the mains and add water.

CAUTION! The rst symptom that the ice cube maker may require more water is the decreasing

volume of each ice cube. This depends on a number of factors.

CAUTION! Aer relling the water, wait at least 3 minutes before restarng the unit - this is the

me needed for the refrigerant to stabilize.

6. To stop making ice cubes, press the ON/OFF switch (4a). The POWER indicator (4e) will start

ashing; the ice cube maker stopped running and is ready to resume. Unplug the ice cube maker

from the mains.

7. If you do not need to use the ice cube maker in the next few hours, remove the unused water.

Place a suitable container under the water drain plug (9), and remove the rubber seal. When the

water stops owing out, place the rubber seal back in.

CAUTION! Add and drain water only with the power cord unplugged from the mains!

123456789101112131415161718192021222324/ 24

Bekijk gratis de handleiding van Kluge KMKD-04M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

Andere merken in Niet gecategoriseerd