Kimo C 310 handleiding
Handleiding
Je bekijkt pagina 16 van 34
If the deviations are too large (> 0,05V or > 0,05mA) between the signal issued and the value
displayed on the multimeter, we recommend that you return the transmitter to our factory.
3.5. Configure the alarms
This part allows to activate and dene the alarms conditions on one or several channels.
One channel must be congured at least (see chapter 3.3).
If no channel has been congured, the transmitter will indicate that the alarms conguration is
impossible.
➢ Press OK.
➢ Enter the security code then press OK.
➢ Go to “Alarms” line then press OK.
The transmitter displays the 4 alarms: “Alarm 1”, “Alarm 2”, “Alarm 3” or “Alarm 4”.
3.5.1 Select the alarm mode
➢ Go to the line of the alarm to congure then press OK.
➢ Press OK on “Mode” line.
The transmitter displays the different available modes:
• None
• Rising edge
• Falling edge
• Monitoring
• Transmitter state
➢ Go to the required mode with Up and Down arrows then press OK.
Details of the available alarms modes:
• Rising edge(1 threshold): the alarm goes off when the measurement exceeds the threshold and stops when it
is below the threshold
• Falling edge(1 threshold): the alarm goes off when the measurement is below the threshold and stops when
it exceeds the threshold.
• Monitoring (2 thresholds): the alarm goes off when the measurement is outside the dened low and high
thresholds.
• Transmitter state: the alarm goes off according to dened conditions (high ambient temperature*, memory
error...)
16
Congure the transmitter
Rising edge
Measurement (m) > Threshold (S) during the time-
delay T1 Alarm activation→
Measurement (m) < Threshold (S) - Hysteresis (H)
during the time-delay T2 Alarm deactivation→
Falling edge
Measurement (m) < Threshold (S) during time-delay T1 →
Alarm activation.
Measurement (m) > Threshold (S) + Hysteresis (H) during
time-delay T2 Alarm deactivation→
*only with the pressure board
Bekijk gratis de handleiding van Kimo C 310, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kimo |
| Model | C 310 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3908 MB |
