Kichler Fit handleiding
Handleiding
Je bekijkt pagina 16 van 84
16 | KICHLER.COM
ATTACHING THE LIGHT KIT
(IF NOT INSTALLING THE DECORATIVE CAP)
Light Kit Housing
Mounting Plate
Mounting Plate Screw
Fig. 22
Fig. 23
Mounting Plate Screw
Mounting
Plate Screw
Dot Label
Dot Label
CAUTION: Before continuing installation, confirm that the
power is still turned o at the main circuit breaker or by
removing the circuit fuse. Turning the power o using a
wall switch is not sucient to prevent electrical shock
.
NOTE: If installing the decorative cap instead of the light kit, see the
"INSTALLING THE DECORATIVE CAP" instructions on the previous page.
Step 1.
Remove the mounting plate screw that is marked with a brown
dot label from the mounting plate. Retain mounting plate screw.
Loosen the
other two mounting plate screws (do not remove). (Fig. 22)
Step 2. Place the key hole slots in the light kit housing over the 2
mounting plate screws that were loosened on the mounting plate. Rotate
the light kit housing (clockwise) until it locks in place against the mounting
plate screws at the narrow ends of the key hole slots.
Align the remaining hole in the light kit housing with the remaining hole in
the mounting plate. Install the mounting plate screw that was removed
from the mounting plate into the aligned holes. Tighten all 3 mounting
plate screws to secure the light kit housing in place. (Fig. 23)
Bekijk gratis de handleiding van Kichler Fit, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Kichler |
| Model | Fit |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 6373 MB |
