Kichler Bead handleiding

Ventilator

Kichler

54 pagina's

PDF beschikbaar

Handleiding

10 | KICHLER.COM

MAKE THE ELECTRICAL CONNECTIONS

FINISHING THE MOTOR INSTALLATION

Step 4.Step 4. If your outlet box has a ground wire (green or bare copper) connect If your outlet box has a ground wire (green or bare copper) connect

it to the fan ground wires : otherwise connect the fan ground wire to the it to the fan ground wires : otherwise connect the fan ground wire to the

mounting bracket. Secure the wire connection with a plastic nut provided.mounting bracket. Secure the wire connection with a plastic nut provided.

After connecting the wires, spread them apart so that the green and white After connecting the wires, spread them apart so that the green and white

wires are on one side of the outlet box and black and blue wires are on the wires are on one side of the outlet box and black and blue wires are on the

other side. other side.

NOTE:NOTE: Carefully tuck the wire connections up into the outlet box. Carefully tuck the wire connections up into the outlet box.

NOTE: NOTE: Fan must be installed at a maximum distance of 30 feet from the Fan must be installed at a maximum distance of 30 feet from the

transmitting unit for proper signal transmission between the transmitting transmitting unit for proper signal transmission between the transmitting

unit and the fan’s receiving unit.unit and the fan’s receiving unit.

Step 1. Step 1. Remove the motor assembly from the hook of the ceiling mounting Remove the motor assembly from the hook of the ceiling mounting

bracket and push up the motor assembly until the two screws on the ceiling bracket and push up the motor assembly until the two screws on the ceiling

mounting bracket are engaged with the slot holes on the canopy of the mounting bracket are engaged with the slot holes on the canopy of the

motor assembly. Rotate the motor assembly slightly until the two screw motor assembly. Rotate the motor assembly slightly until the two screw

heads are in the slot holes. Install the two screws previously removed and heads are in the slot holes. Install the two screws previously removed and

tighten all four screws. (Fig. 11)tighten all four screws. (Fig. 11)

Step 2.Step 2. Push the canopy trim ring up until it locks into place at the top of the Push the canopy trim ring up until it locks into place at the top of the

canopy. (Fig. 12)canopy. (Fig. 12)

Fig. 11

Fig. 12

Canopy Trim Ring

Bekijk gratis de handleiding van Kichler Bead, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.