Handleiding
Je bekijkt pagina 16 van 90
Installation
Instructions
Page 15
Locking screw 10X 1/ 4 panhead
screws (for Vinyl-Clad window)(on some models)
Phillips
7/16 inch Locking screw and
Flat washer for window panels
3 / 4 or 1/2)inch Long
Hex-head Screw
Safety Lock
1 / 2 inch Long screw and Locknut
3 / 4 inch Long Flat Head
Bolt and Locknut
Sill Angle Bracket
Long hex-head locking
screw for top angle, side
retainer 5 /16 inch Long
2ea.
7
1
4ea.
2ea.
2
10
Foam insert
2
Window sash
seal foam
1
R1 hardware
2
(10 *3/4 *1/12 )
NOET:R1 hardware and Weather stripping is only for
models with capacity larger than 15000 Btu/h.
Weather stripping
5
Safety Lock
(for Vinyl-Clad window)(on some models)
2
2
Lock Frame(For Wooden
windows)(on some models)
2
3 / 4 inch Long Screw(on some models)
2
3. Check your storm windows-- if your
storm window frame does not allow the clea-
rance required, correct by adding a piece of
wood as shown in Fig.E,or by removing storm
window while room air conditioner is being
installed.
4 .Check for anything that could block
airflow- check area outside of window for
things such as shrubs, trees, or awnings. Inside,
be sure furniture, drapes, or blinds will not stop
proper airflow.
5. Check the available electrical service-
Power supply must be the same as that shown
on the unit serial nameplate. Power cord is 48
inches long. Be sure you have an outlet near.
6. Carefully unpack air conditioner- Remove
all packing material. Protect floor or carpet from
damage. Two people should be used to move
and install unit.
Tools Required
A large flat blade screwdriver; Tape measure;
Adjustable wrench or pliers; Pencil; Level Socket
wrenches; Phillips Screwdriver.
Hardware(Packed with the unit)
1
Front Grille
Front Panel
shipping
screws
Remove Air Conditioner from Cabinet
NOTE:
Remove any packaging material from
cabinet exterior.
1. Pull down front grille and remove filter.
(See Fig.1).
2. Lift front grille upwards and place to one side.
3. Locate the four front screws and remove. These
screws will be needed to re-install the front panel
(see Fig.2).
4. Push metal cabinet side to release plastic tabs
on each side of front panel (see Fig.3).
5. Gently lift front panel off unit(see Fig.3A).
6. Disconnect the connector plug of the display
panel from the unit and place front panel to
one side(see Fig.4).
7. Remove shipping screws from top of unit and
also on the side by the base if installed(see Fig.5).
8. Hold the cabinet while pulling on the base
pan handle, and carefully remove the unit.
9. Add two foam inserts to holes in top of
cabinet where shipping screws were
removed from (see Fig .6)
Fig.1 Fig.2
Fig.3
Fig.3A
Fig.4
Fig.5
Fig.6
Sill angle bracket
2
(on some models)
Bekijk gratis de handleiding van Keystone KSTAW08CE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Keystone |
| Model | KSTAW08CE |
| Categorie | Airco |
| Taal | Nederlands |
| Grootte | 15608 MB |
