Karcher SC 1 Multi & Up Extra handleiding
Handleiding
Je bekijkt pagina 9 van 20
English 9
● LED display light to indicate the various modes such
as heating, ready for use, steam operation and des-
caling cartridge change.
● Switching the steaming function on and off.
1. Hold the device firmly with the handle or place the
device on a solid surface.
2. Plug the mains plug into a socket.
The steam switch flashes yellow and the device
heats up.
Illustration Q
3. The device is ready for use after approx. 30 seconds
and the steam switch lights up green constantly.
Illustration R
4. To switch on steam operation, press the steam
switch lightly once.
Steam leaks out.
During steam operation, the steam switch pulses
green.
Illustration S
Note
After 5 minutes of continuous steaming, the steam
switches off automatically. This prevents the pump from
running dry if it is not noticed that the water reservoir is
empty.
● If necessary, top up with water and press the steam
switch once lightly to continue cleaning.
Refilling water
Note
If there is a lack of water, a loud noise is emitted be-
cause the pump draws air and there is no visible steam.
Note
The water level can be seen through the transparent
fresh water tank.
Remove the water reservoir and fill with 200 ml tap
water, see chapter Filling water
Illustration F
Interrupting operation
ATTENTION
Material damage due to condensate/moisture
To prevent material damage during longer work breaks,
see chapter Storing the device
Note
In order to save energy, we recommend that you switch
off the device for breaks in operation of longer than 20
minutes, see chapter Switching off the device
● To switch off steam operation, press the steam
switch lightly once.
Illustration T
Steam operation is switched off.
Switching off the device
1. To switch off the steam operation when needed,
press the steam switch lightly once.
Steam operation is switched off and the steam
switch lights up green constantly.
2. Pull the mains plug out of the socket.
The device is switched off.
Illustration T
ATTENTION
Device damage due to water putrefaction
The water in the reservoir may putrefy if the device is
not put into operation for more than 2 months.
Drain the water reservoir before longer breaks in oper-
ation.
● Drain the water reservoir.
Illustration U
Storing the device
ATTENTION
Material damage due to condensate/moisture
After cleaning, moisture remaining on the accessories
(e.g. floor cleaning cloth, floor nozzle, hand nozzle) or
on the device itself can damage surfaces or floor cover-
ings.
Remove the accessories after the cleaning work and dry
them like the device.
Do not place or store the accessories/device on sensi-
tive storage areas or surfaces.
1. Disconnect the accessories from the device.
2. Wrap the mains connection cable around the device
handle as required.
Illustration V
3. Allow the accessory to dry.
4. Store the device in a protected, dry location that is
protected from frost.
Important application instructions
Cleaning coated or painted surfaces
ATTENTION
Damaged surfaces
Steam can loosen wax, furniture polish, plastic coatings
or paint and edge band from edges.
Do not direct the steam at glued laminated edges as the
edge band may loosen.
Do not use the appliance for cleaning unsealed wood or
parquet floors.
Do not use the appliance for cleaning painted or plastic
coated surfaces such as kitchen or living room furniture,
doors or parquet.
1. To clean these surfaces, steam a cloth briefly and
use it to wipe over the surfaces.
Glass cleaner
ATTENTION
Glass breakages and damaged surfaces
Steam can damage sealed points of the window frame
and, at low outside temperatures, lead to tension on the
surface of window panes and hence to glass breakages.
Do not direct the steam at sealed points on the window
frame.
At low outside temperatures, heat up the window panes
by gently steaming the full surface of the glass.
Clean the window area with a hand nozzle and cov-
er. To remove the water, use a squeegee or wipe the
surfaces dry.
Freshening up textiles
Prior to using the appliance, always check the compati-
bility of the textiles at a concealed point: Steam down
the textile, allow it to dry and then check it for any
change in colour or shape.
How to use the Accessories
Steam nozzle/steam gun
The steam nozzle or steam gun can be used for the fol-
lowing application areas without accessories:
● For removing slight creases from the hanging cloth-
ing items: Steam the clothing item from a distance of
10-20 cm.
● For wiping damp dust: Steam a cloth briefly and use
it to wipe over the furniture.
Bekijk gratis de handleiding van Karcher SC 1 Multi & Up Extra, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Karcher |
| Model | SC 1 Multi & Up Extra |
| Categorie | Stoomreiniger |
| Taal | Nederlands |
| Grootte | 3473 MB |