JET Skyhyker SKY25 handleiding
Handleiding
Je bekijkt pagina 14 van 40
7 Operation
Figure 7-1: Mast/Legs Locking Plate Open
Read and understand this entire owner’s manual
before operating this material lift. Failure to comply
with instructions and safety warnings in this man-
ual and on the lift may cause serious injury.
This material lift is designed and intended for use
by properly trained and experienced personnel
only. Learn how to operate this lift properly and
safely. If you are not familiar with the proper and
safe operation of this lift, do not use it. Follow
proper and safe lifting practices.
Do not use this material lift to lift, lower, support, or
transport people. Do not lift or support loads over
the top of people. Never allow anyone under the
mast T-bar or an elevated load.
Always operate this material lift while standing
between the two rear, shorter legs and behind the
mast. Wear proper safety gear such as hard hat,
safety glasses, steel-toe shoes, and gloves.
Do not attempt to lift any load while the SkyHyker
is in the travel (hoizontal, non-load) position.
Do not move the material lift to different locations
while a load is attached. Have material at the lift
location before moving the material lift in place.
Before lifting any materials, the mast must be in the vertical,
load-bearing position. Follow the steps below to set the mast
vertically.
1. On the base, lift and swing open the red mast/legs locking
plate (see Figure 7-1). This unlocks the base assembly legs
and opens the square tube/mast slot. Leave this locking
plate open until instructed to close it.
7.1 PREPARING MAST FOR LIFTING
2. If legs are not in the widest, lift-ready position, pivot legs
out to their widest setting. Do this by grasping the legs
near the caster cylinders and moving the legs outward.
See Figure 7-2.
3. Lock all four wheel casters (see Section 7.10 LOCKING
CASTERS).
Figure 7-2: Pivot Legs to Widest Position
When the lift is not in use, you must place the load
cable hook securely into the hook bracket locat-
ed on the mast. Tighten the load winch cable to
remove all slack.
Do not overload the lift. Follow the load ratings
specied in Section 1.7 LOAD RATINGS.
11 |
Chapter 7: Operation
Bekijk gratis de handleiding van JET Skyhyker SKY25, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | JET |
| Model | Skyhyker SKY25 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16855 MB |
