JET JWJ-8HH-BLK handleiding
Handleiding
Je bekijkt pagina 12 van 28
12
7.2.5 Installing Outfeed Table
Adjustment Handwheel and Infeed Table
Adjustment Handle
Outfeed Table Adjustment Handwheel
Refer to Figures 7-13 & 7-14:
1. Place key (A) into key slot of the handwheel
shaft (B).
2. Align key notch in handwheel (C) with key and
handwheel shaft and slide handwheel onto
shaft.
3. Attach handwheel to shaft using M6x10 screw
and 6mm flat washer (D).
Figure 7-13
Figure 7-14
Infeed Table Adjustment Handle
Refer to Figures 7-15:
1. Screw infeed table adjustment handle (A) into
threaded mounting hole under infeed table.
Figure 7-15
7.2.6 Installing Cutterhead Guard
Refer to Figures 7-16:
1. Place cutterhead guard (A) into mounting hole
as shown in Figure 7-16.
Figure 7-16
7.3 Dust Collection
Refer to Figures 7-17:
A jointer produces a significant volume of wood
chips and dust. The use of a dust collection system
is strongly recommended. It will help keep the shop
clean, as well as reduce potential health hazards
caused by inhalation of wood dust. We recommend
your dust collector has a minimum rating of 400
CFM.
JET has a full line of dust collection systems
available. See your dealer or visit our website at
www.jettools.com.
Connect the hose of your dust collection system to
the 4-inch dust port on the jointer (A). Secure hose
tightly with a hose clamp.
Figure 7-17
Bekijk gratis de handleiding van JET JWJ-8HH-BLK, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | JET |
| Model | JWJ-8HH-BLK |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9382 MB |
