Janome MyLock 454D handleiding
Handleiding
Je bekijkt pagina 9 van 48
7
Changing Needle
To attach the needle on the right:
3.
Insert a new needle into the needle clamp with the at
side to the back until the top of the needle touches
the stopper pin, then tighten the needle clamp screw
on the right clockwise.
To attach the needle on the left:
3.
Insert a new needle into the needle clamp with
the at side to the back until the top of the needle
touches the edge of the needle bar, then tighten the
needle clamp screw on the left clockwise.
(4) Needle clamp
(5) Needle
(6) Needle stopper pin
(7) Edge of needle bar
(8) Needle clamp screws
(9) Flat side
1.
Turn the handwheel toward you to raise the needle to
its highest position.
(1) Handwheel
2.
Loosen the needle clamp screw by turning it
counterclockwise. Remove the needle from the
needle clamp.
(2) Needle clamp screw on the left
(3) Needle clamp screw on the right
WARNING:
Turn OFF the power switch and unplug the machine
before changing the needle.
Checking the needle
To see if the needle is in good condition, place the at
side of the needle onto something at (needle plate, glass
etc.). The gap between the needle and the at surface
should be consistent.
(1) Flat side
(2) Something at
(3) Gap
(1)
(2)
(3)
(4)
(5)
(7)
(7)
(6)
(6)
(9)
(2)
(3)
(8) (8)
NOTE:
Use an HAx1 SP #14 or #11 needle.
An HAx1 SP #14 needle is set on the machine.
NOTE:
Never use a bent or blunt needle.
NOTE:
When the needles are set correctly, the left needle is
higher than the right one.
1.
2.
3.
(1)
Bekijk gratis de handleiding van Janome MyLock 454D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | MyLock 454D |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 6651 MB |
