Janome MyLock 454D handleiding
Handleiding
Je bekijkt pagina 10 van 48
8
Presser Foot Lifter
The presser foot lifter raises and lowers the presser foot.
Raise the presser foot lifter before you thread the
machine.
You can raise the foot about 1.5 mm (1/16˝) higher than
the normal up position by exerting more pressure when
lifting the presser foot. This allows for removing and
attaching the needle plate and helps you to place layers
of thick fabric.
Always lower the presser foot lifer when you start sewing.
(1) Presser foot
(2) Presser foot lifter
(3) Normal up position
(4) Extra lifted position
NOTE:
Tension disks open and the thread tension will be
released when the presser foot lifter is raised.
(5) Tension disks
Replacing the Presser Foot
Removing the Presser Foot
Turn the handwheel toward you to raise the needle to its
highest position. Raise the presser foot lifter.
(1) Needle
(2) Presser foot lifter
Press the lever located on the back of the foot holder.
The presser foot will drop off.
(3) Foot holder
(4) Lever
CAUTION:
Turn OFF the power switch and unplug the machine
before removing or attaching the foot.
Attaching the Presser Foot
Place the presser foot, so that the pin on the foot lies just
under the groove of the foot holder.
Lower the foot holder to lock the foot into place.
Raise the presser foot lifter to check that the presser foot
is secure.
(1) Groove
(2) Pin
(3) Lever
(1)
(2)
CAUTION:
Do not push the lever from the top.
(2)
(3)
(4)
(3)
(1)
(2)
(1)
(2)
(5)
(3)
(4)
(5)
Bekijk gratis de handleiding van Janome MyLock 454D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | MyLock 454D |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 6651 MB |
