Janome MyLock 454D handleiding
Handleiding
Je bekijkt pagina 8 van 48
6
Setting the Thread Guide Bar
Pull the thread guide bar up as far as it will go.
Turn the thread guide post so that the thread guides are
right above the spool pins.
(1) Thread guide bar
(2) Thread guide post
(3) Thread guide
(4) Stoppers
(5) Spool pin
(3)
(1)
(4)
(5)
(2)
(2)
(1)
(3)
(1)
(2)
(7)
(6)
(2)
(5)
(4)
Setting the Spools
You can use two types of spools for this machine.
Spool cones
When using spool cones, attach the spool holders to the
spool pins.
If the thread slips down from a spool cone during the
threading and/or sewing, put the net over the spool cone
as shown to prevent jamming.
* The spool holder cap and net are optional accessories.
(1) Spool cone
(2) Spool holder
(3) Net
Small spools
When using small spools, remove the spool holders from
the spool pins.
(2) Spool holder
(4) Small spool of thread
(5) Spool pin
Place the spool with its slit side up, and put the spool
holder cap on top of it.
(6) Slit
(7) Spool holder cap
NOTE:
If the spool cone is unstable, insert the spool holder
into the spool cone all the way before setting it to the
spool pin.
NOTE:
Be sure to snap both stoppers into places.
Bekijk gratis de handleiding van Janome MyLock 454D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | MyLock 454D |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 6651 MB |
