Janome Memory Craft 100E handleiding
Handleiding
Je bekijkt pagina 94 van 112
92
Warning Sign Cause Try this
The bobbin winder spindle is shifted to the right. Shift the bobbin winder spindle
to the left for stitching (refer to
page 15).
The machine stops due to overload. Wait for at least 15 seconds to
restart. Remove tangled threads
around take-up lever, hook race
and auto thread cutter device.
The machine is malfunctioning. Contact the service center or the
store from whom the machine
was purchased.
This message appears if an auto-thread
cutting error occurred due to a problem of the
motor initialization, a problem in the electronic
components or a thread tangling in hook area.
Turn the power OFF and remove
tangled threads around the hook
race and auto thread cutter
device, then turn the power ON.
If this message does not
disappear, contact the service
center or the store from whom the
machine was purchased.
Problems and Warning Signals
If a buzzer sounds and the visual touch screen shows a warning sign, follow the guidance below.
Bekijk gratis de handleiding van Janome Memory Craft 100E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janome |
| Model | Memory Craft 100E |
| Categorie | Naaimachine |
| Taal | Nederlands |
| Grootte | 24843 MB |
