Janitza 800-CON-RJ45 handleiding
Handleiding
Je bekijkt pagina 18 van 36
Module800-CON-RJ45 www.janitza.com
18
5. Check the fit of your measurement-device and
module series and mount end brackets.
Basic device
Transfer module 800-CON-RJ45
with output bus connector
End bracket
DIN rail
INFORMATION
Always install the 800-CON-RJ45 transfer module
with output bus connector at the end of your mea-
surement device and module topology (see Sect. “6.
Installation” on p. 22).
4.2 Mounting the transfer module with input
bus connector
For spatially distant module series, mount the
800-CON-RJ45 transfer module with input bus
connector while the system is disconnected from
the power supply:
1. Press in the open bottom bolts on the rear of the
transfer module.
2. If not already done, press the supplied input bus
connector (JanBus interface) into the sockets on
the back of the transfer module.
Input bus connector
Bottom bolt, open
Bottom bolt, pressed in
Input bus connector,
rotated
press
Bekijk gratis de handleiding van Janitza 800-CON-RJ45, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Janitza |
| Model | 800-CON-RJ45 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5042 MB |
