Intergas Xtend Split handleiding
Handleiding
Je bekijkt pagina 66 van 88
66
11.6 Parameter list
The parameters are set at the factory in accordance with the table below. These parameters can only be
changed using the service code. Please note: Installers must be fully versant with the below parameters,
incorrect adjustment or setting can damage the equipment.
Parameter Category Setting
Default
value Description/Setting range
P000P000
General Device in use. 1
0 = no
1 = yes
P004P004
Connections
Room heating connected to the
system
1
0 = no
1 = yes
P006P006
Connections External outdoor sensor connected. 0
0 = no
1 = yes
P007P007
Connections Source of the external temperature. 0
0 = automatic. (external sensor,
internet, outdoor unit sensor)
1 = external outdoor sensor T42 (P006 = 1)
2 = internet
3 = outdoor unit sensor
4 = CH-Boiler (via OpenTherm)
P009P009
Connections not applicable - deactivated
P010P010
Connections not applicable - deactivated
P011P011
Connections not applicable - deactivated
P015P015
Calibration External outdoor sensor T42. 0.0 -12.7 ºC to 12.7 ºC (increments of 0.1)
P016P016
Calibration Return sensor T04. 0.0 -12.7 ºC to 12.7 ºC (increments of 0.1)
P017P017
Calibration Flow sensor T03. auto -12.7 ºC to 12.7 ºC, auto
P018P018
Calibration External temperature flow sensor T43. auto -12.7 ºC to 12.7 ºC, auto
P020P020
Connections
Setting minimum CH pressure
threshold value
0.5 0.0 to 4.0 bar (increments of 0.1 bar).
P021P021
Connections
Use of the OpenTherm pressure sensor
in the existing boiler.
1
0 = Does NOT use the OpenTherm pressure
sensor
1 = DOES use the OpenTherm pressure sensor
P064P064
Connections
Heating demand input type through
Connector X2 (contacts 5 and 6)
1
0 = deactivated (Opentherm default)
1 = ON/OFF based on heating demand
P065P065
Connections
Heating demand input type through
Connector X2 (contacts 3 and 4)
- deactivated
P066P066
Connections
Function of digital output 1 relay
(Connector X3, contacts 7, 8 and 9)
0
0 = not in use
1 = signal, cooling active
2 = signal, heating active
3 = control of the secondary CH pump
4 = Hybrid boiler ON/OFF
5 = indoor unit on (P000 = 1)
6 = secondary pump (even during defrosting)
7 = locked status
8 = locked/notification status
9 = heat pump malfunction
10 = Sec. pump (active during heat pump and
boiler)
Bekijk gratis de handleiding van Intergas Xtend Split, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Intergas |
| Model | Xtend Split |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11570 MB |
