InfiRay Rico Hybrid HYH75W handleiding
Handleiding
Je bekijkt pagina 9 van 31
14 15
13. MOUNTING THE RICOHYBRID
Installing the IRAY-AC106 Mount
Before using the RICOHYBRID, install the IRAY-AC107 Advanced
Recoil-Mitigating Picatinny Mount (17) to the mount interface on the
base of the RICOHYBRID.
IRAY-AC107 (17)
M3 Screws (20)
1. Install the IRAY-AC107 (17) to the base of the RICOHYBRID
using a 2.5mm hex key and the M3screws (20) supplied in the
package.
2. Install the RICOHYBRID to the rifle and adjust its position so that
it produces a clear image and is comfortable for the shooter.
3. When the location is suitable, remove the M3 screws one at a time
and apply a small amount of blue Locktite242 to the threads.
4. Reinsert each screw and tighten to 20 in/lbs.
5. Allow the threadlocker to dry.
NOTE:
Please note, torque is inch-pounds, NOT foot-pounds. If you
do not have a torque wrench, apply until snug. Do not overtighten.
When the threadlocker is dry, install the mount and rifle scope to the
Picatinny rail of your rifle.
1. Press the locking button (21) and pull the locking lever (22) to
open each throw lever.
2. Install the mount to the Picatinny rail.
Locking Lever (22)Locking Button (21)
3. Press the levers closed to lock the mount in place. You will hear
the lever and locking button click.
The RICOHYBRID is now ready to be zeroed. See Zeroing the
RICOHYBRID on page22 for instructions.
Adjusting the Throw Lever Tension
If necessary, you may loosen or tighten the tension of the throw
levers by adjusting the nuts(23).
Nut (23)
1. Open the throw levers. This will cause the adjustment nuts (23)
to protrude on the opposite side of the mount.
2. Use the prong-side of the included spanner tool to turn the
adjustment nut clockwise to tighten, or counterclockwise to
loosen, to achieve the correct amount of tension. You should
not feel any tension on the locking lever when closing until it
reaches a 45-degree angle.
14. OPERATING INSTRUCTIONS
WARNING!
Don’t point the objective lens towards any intense energy sources, such as laser radiation or the sun.
This may render the electronic components inoperative. The warranty does not cover damage caused
by improper operation.
Using the Control Buttons
The RICOHYBRID is operated via four control buttons and a
metal tactile Rotary Encoder. The easy-to-find Rotary Encoder
provides audible and tactile feedback when twisted or pressed.
The control buttons and Rotary Encoder can be used to perform
shortcut operations from the home screen, as well as in the menu
and full-screen interfaces. See Description of Control Buttons and
Shortcuts on page6 for shortcut button details.
Powering On
1. Open the objective lens cap (1).
2. Long press the Power Button for 3 seconds to turn on the rifle
scope. The InfiRay Outdoor logo will appear.
3. To determine the current battery charge, check the battery status
icon in the top status bar.
Bekijk gratis de handleiding van InfiRay Rico Hybrid HYH75W, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | InfiRay |
| Model | Rico Hybrid HYH75W |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8175 MB |
