Handleiding
Je bekijkt pagina 13 van 20
13
Cleaning & Maintenance (Cont.)
For Serious Faults:
• If you experience one of the listed faults shown in
the table on page 13, or if another emergency or
serious fault occurs, immediately power o the dryer
using the controls, and then disconnect the power
from the source.
• If a serious fault occurs, DO NOT attempt any repairs
yourself, instead wait for a service agent to do so.
• For assistance or organise an authorised service agent
contact After Sales Support by calling 1300 11 4357,
or by emailing support@residentiagroup.com.au.
• Please note that if a service agent is asked to attend
whilst the product is under warranty and nds that
the problem is not the result of an appliance fault,
then you may be liable for the cost of the call out
charge.
• The appliance must be accessible for the service
agent to perform any necessary repair. If your
appliance is installed in such a way that a service
agent is concerned that damage will be caused to
the appliance or your home, then they will not
complete a repair.
Problem Solution
The display is not turning on.
• Check the mains power plug has been properly inserted and the power
is on.
• Check if there is a power outage in your home or area. If the problem
persists contact our Support Team for guidance.
‘F:UL’ is lit on the display.
• Check the water container. If it is full, pour out the condensate water,
reinsert the water container and then restart the dryer.
• If ‘F:UL’ is still appearing despite the water container being empty, we
recommend that you contact our Support Team for guidance.
The symbol is lit on the display.
• Check the lint lter. Carefully remove the lter and clean the
accumulated lint. After reinserting the lter, restart your dryer.
• If the icon is still appearing despite the lint lter being clean, we
recommend that you contact our Support Team for guidance.
The drying program is not starting.
• Check the mains power plug has been properly inserted and the power
is on.
• See if the water container is full. Additionally, check if the lint lter
is clean.
• Ensure that the dryer door is properly closed, and no garments
are snagged.
• Restart the dryer, however if the problem persists contact our
Support Team.
The drying program either took too
long or the clothes were not dry
enough.
• See if the water container is full. Additionally, check if the lint lter
is clean.
• Consider using a higher drying intensity level, or alternatively use
the Time Dry program to extend the time clothes are spent drying.
• Ensure you are not attempting to dry over the appliance’s maximum
capacity.
There are humming noises while the
dryer is running.
• The compressor is operating. This is normal and does not indicate a fault.
The dryer turns itself o after
a program has ended.
• This is normal, as the appliance turns o automatically to save energy.
For Minor Faults
Troubleshooting
Bekijk gratis de handleiding van InAlto IHPD800W, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | InAlto |
| Model | IHPD800W |
| Categorie | Wasdroger |
| Taal | Nederlands |
| Grootte | 1842 MB |
