IKEA ÖSTVEDA 105.681.48 handleiding
Handleiding
Je bekijkt pagina 22 van 44
ENGLISH 22
Changing the programme does not change
the delay time and the LED will remain on.
When you press the DELAY START button,
the last setting made will be displayed.
Countdown and Programme start with DELAY
START
• When the delay is set on a programme:
after pressing "START/OK".
• The "DELAY START" light stays on until the
end of the time.
• The delayed time countdown starts
showing on the display "START IN XX: XX".
• The time will be displayed with 30-minute
intervals over 24 hours and one-minute
intervals over the last 2 hours.
• Pressing any button (except the "ON/ OFF,
START/OK" buttons for 3 seconds, the
programme name "P XX" is displayed (P +
programme number) for one single scroll
and then the delay time is displayed again.
In the event of a power failure or
shutdown, the dishwasher stores the
time remaining at the start, which will
be resumed at the point where it was
interrupted once the power supply is
restored or the machine is switched on
again.
If you want to cancel the delayed start
proceed as follows:
• Press and hold the "START/OK" button for
at least 3 seconds. The display will show
"RESET" and beeps will sound.
• The delayed start and the selected
programme will be cancelled. Two dashes
will appear on the display.
• At this point, if you want to start the
dishwasher, you will need to set the
desired programme again and select the
option buttons if necessary.
Water softener
Depending on the source of the supply, water
contains varying amounts of limestone and
minerals which are deposited on the dishes
leaving whitish stains and marks. The higher
the level of these minerals present in the water,
the harder the water is.
The dishwasher is fitted with a water softener
unit which, through the use of special
regenerating salt, supplies softened water for
washing the dishes. The degree of hardness of
your water can be obtained from your water
supply company.
Regulating the water softener
The water softener can treat water with a
hardness level of up to 90 °fH (French grading) or
50 °dH (German grading) through 8 settings.
The settings are listed in the table below, with
the relative mains water to be treated.
Level
Water hardness
Use of
Regenerating
salt
Water softener
setting
°fH
(Franch)
°dH
(German)
0 0-5 0-3 NO S0
1 6-10 4-6 YES S1
2 11-20 7-11 YES S2
3 21-30 12-16 YES S3
4* 31-40 17-22 YES S4
5 41-50 23-27 YES S5
6 51-60 28-33 YES S6
7 61-90 34-50 YES S7
* The softener unit is set in the factory at
level 4 (S4) as this satisfies the requirements of
the majority of users.
Bekijk gratis de handleiding van IKEA ÖSTVEDA 105.681.48, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IKEA |
| Model | ÖSTVEDA 105.681.48 |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 4787 MB |
