IKEA ÖSTVEDA 105.681.48 handleiding
Handleiding
Je bekijkt pagina 23 van 44
ENGLISH 23
Regulate the setting of your water softener
unit according to the degree of hardness of
your water, as follows:
The dishwasher must ALWAYS be off before
start of this procedure.
• Switch on the dishwasher with the
"ON/OFF" button.
• Keep the "SETUP 5 SEC" button pressed for
about 5 sec.
• The "SETTINGS" message appears on the
display.
• By pressing the "PROGRAM SELECTION"
key you can select the successive
parameters to be adjusted.
• Select the "SOFTENER" setting.
• Press the "START/OK" button to confirm
the selected parameter.
• The set level appears on the display (the
factory-set level is "S4").
• Press the "PROGRAM SELECTION"
buttons to choose different settings levels.
• Confirm your choice by pressing
"START/OK".
• "SOFTENER" will scroll on the display.
• To exit the menu, press the "ON/OFF"
key.
To change the water softener setting again,
follow the same procedure.
WARNING: If you cannot complete the
procedure, turn the dishwasher off by
pressing the "ON/OFF" button and start
the procedure again from the beginning
(STEP 1).
Information on resin regeneration with salt
The regeneration phase is carried out at the
end of a washing cycle.
Approximately 3.5 litres of water are consumed
in the resin phase, with an energy consumption
of approximately 1Wh and an increase in cycle
time of approximately 7 minutes.
For the Eco cycle, it is as shown in the table.
Level Display Frequency
S0 DISPLAY S0 Never
S1 DISPLAY S1 1 every 9 cycles
S2 DISPLAY S2 1 every 7 cycles
S3 DISPLAY S3 1 every 5 cycles
S4 DISPLAY S4 1 every 4 cycles
S5 DISPLAY S5 1 every 3 cycles
S6 DISPLAY S6 1 every 2 cycles
S7 DISPLAY S7 Every cycle
Rinse aid
When it becomes necessary to fill the rinse aid
container, the display will indicate the lack of
rinse aid.
This has been factory-set to level 4, as this
satisfies the majority of users.
Adjusting the amount of rinse aid
ALWAYS start the procedure with the
dishwasher turned off.
• Switch the appliance on, press "ON/OFF"
button.
• Hold the "setup 5 sec" button, a short
beep will sound
• The "SETTINGS" message appears on the
display.
• Press the "PROGRAMME SELECTION"
buttons to navigate the submenu.
• Choose the "RINSE AID" option. Press
"START/RESET" to access the regulation
levels.
• Press "START/OK" to access the regulation
levels.
Bekijk gratis de handleiding van IKEA ÖSTVEDA 105.681.48, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IKEA |
| Model | ÖSTVEDA 105.681.48 |
| Categorie | Vaatwasser |
| Taal | Nederlands |
| Grootte | 4787 MB |
