IK Multimedia iLoud Micro Monitor Pro handleiding
Handleiding
Je bekijkt pagina 15 van 72
iLoud Micro Monitor Pro
Advanced features and insights
15
Front LED
The front LED will show important information about the iLoud Micro Monitor Pro’s status.
Operating status
• STEADY WHITE: The unit is operating in normal mode with no issues.
• BREATHING WHITE: The unit is operating in ARC Calibration mode.
• BLINKING WHITE: Calibration calculation phase in process.
• BLINKING ORANGE: ARC measurement sweep in progress.
• STEADY CYAN: The unit is operating in normal mode with an active voicing different than default. Refer to
the X-MONITOR manual for voicing information.
• STEADY BLUE: The unit is operating in DFU mode. (see paragraph “DFU mode”).
Faults reporting
• STEADY RED: This is caused by input signal clipping. Try reducing the input volume. If no audio is being
played but the LED stays STEADY RED, the unit has detected a hardware fault. If this is not solved with a
power cycle, please contact IK Multimedia Customer Support.
• BLINKING RED: The unit is reducing its output power to avoid damaging the speakers. Reducing the input
volume or lowering the volume from the back panel should fix this issue. If no audio is being played but the
LED keeps BLINKING RED, the unit has detected a hardware fault. If this is not solved with a power cycle,
please contact IK Multimedia Customer Support.
DFU mode
Firmware updates of your iLoud Micro Monitor Pro are managed by the X-MONITOR control software available
for download In IK Product Manager after registering your unit.
In the unfortunate event of an unsuccessful firmware update (I.E., in case of a power loss), the unit could
experience issues and not be able to start up properly.
Booting the device in DFU mode will allow the X-MONITOR app to perform a firmware recovery procedure and
restore the unit to proper working conditions.
(please refer to the X-MONITOR app manual for detailed information on the firmware recovery procedure).
To boot iLoud Micro Monitor Pro in DFU mode, please hold the LF EXT button and plug the power cord into the
unit.
The front LED will turn steady blue to indicate that DFU mode is active.
To exit DFU mode, disconnect the power cord and wait until the front LED turns off.
Re-connect the power cable and the unit should power up in normal mode.
Bekijk gratis de handleiding van IK Multimedia iLoud Micro Monitor Pro, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IK Multimedia |
| Model | iLoud Micro Monitor Pro |
| Categorie | Speaker |
| Taal | Nederlands |
| Grootte | 6360 MB |