IFM AL1327 handleiding
Handleiding
Je bekijkt pagina 24 van 125
AL1327 IO-Link master with EtherNet/IP interface
24
Parameter Description Value range Access
Independent mode EtherNet/IP configuration mode • Independent mode off: Configuration
via fieldbus PLC
• Independent mode on: Configuration
via the device
rw
1
2
Process data mode Enable / disable explicit PD mode and
select the process data to be transmit-
ted (connection type)
• Explicit process data mode off: Explicit
PD mode disabled
• Explicit process data mode with IO-Link
I/O + Acyclic + Diag: Explicit PD mode
enabled -- IO-Link inputs/outputs,
acyclic data and diagnostic data is
transmitted
• Explicit process data mode with IO-Link
I/O + Acyclic: Explicit PD mode
activated -- IO-Link inputs/outputs and
acyclic data is transmitted
• Explicit process data mode with IO-Link
I/O: Explicit PD mode enabled -- IO-
Link inputs/outputs are transmitted
rw
1
3
Process data length Length of process data (per IO-Link
port)
• 2 bytes input 2 bytes output: 2 bytes
input data, 2 bytes output data
• 4 bytes input 4 bytes output 4 bytes
input data, 4 bytes output data
• 8 bytes input 8 bytes output 8 bytes
input data, 8 bytes output data
• 16 bytes input 16 bytes output 16 bytes
input data, 16 bytes output data
• 32 bytes input 32 bytes output 32 bytes
input data, 32 bytes output data
rw
1
2
Swap Swap the order of the bytes in the data
word of the process data
• off: as Array of Bytes
• on: as Integer16 value; during an
update of the process data, the bytes
are exchanged
rw
1
2
1
Read and write
2
The parameter can only be changed if no connection to the fieldbus controller is active
3
Parameters can only be changed in "Independent" configuration mode
Requirements:
ü The parameter setting software has been started.
ü The connection to the device has been established.
ü The detailed view of the device is active.
u Select the [Fieldbus] menu.
w The menu page shows the current settings.
u Set the configuration mode.
u Optional: Select connection type.
u Set arrangement of the bytes in the process data.
u Save the changes on the device.
w EtherNet/IP configuration mode is set.
9.1.9 Ports: Setting the operating mode Pin 4 (US)
Pin 4 of ports X01...X08 supports the following operating modes:
• Disabled: No data transmission at pin 4 (C/Q) of the port
• Digital input: Binary input signal at pin 4 (C/Q) of the port
• Digital output: Binary output signal at pin 4 (C/Q) of the port
• IO-Link: IO-Link data transmission via pin 4 (C/Q) of the port
Bekijk gratis de handleiding van IFM AL1327, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | IFM |
| Model | AL1327 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10357 MB |
