Hymer Exsis I (2025) handleiding
Handleiding
Je bekijkt pagina 116 van 240
8 Electrical system
116 Exsis I/T - 01/23-1 - EHG-0027-02EN
8.5 HYMER Smart Battery System
The HYMER Smart Battery System consists of one or more lead-fleece bat-
teries (hereinafter called lead batteries) and one or two HY-Tec lithium bat-
teries 135 (hereinafter called lithium batteries). Both are living area batteries.
Do not make any changes to the installation of the lithium battery carried
out at the factory.
Do not open the lithium battery.
Observe the recommended operating temperature between 15 and
25 °C. Take any further details on the operating temperature from the
manufacturer's instruction manual.
Fully charge the battery system every 6 months.
Switch the transformer/rectifier of for installation and maintenance.
Remove the fuses between lead-acid battery and lithium battery for in-
stallation and any work on the wiring.
If the battery capacity indicator does not reach 100 % any more after a
longer charging time, contact the customer service.
Transport and dispose of the lithium battery only as prescribed by the
manufacturer.
Observe the manufacturer's instruction manual.
The lithium battery consists of six modules and is connected in parallel to
the default lead battery. The lithium battery tolerates frequent charge cycles
better than the lead battery and takes up most of the charge cycles. This
extends the lifetime of the lead battery.
The lithium battery is equipped with a protective function against overload
and total discharge.
The lithium battery is fitted under the L-seating group and can be accessed
by an external flap
The integrated intelligent discharge management ensures that, while dis-
charging, the current is first drawn from the lithium battery and only then
from the lead battery. When the lithium battery is providing the current, the
lead battery serves as backup storage.
In case of large power requirement, the current is drawn in parallel from
both, the lithium battery and the lead battery.
During the charging procedure, the lead battery is charged in the first place,
and then the lithium battery.
Fully charge the battery system after recommissioning or longer periods
of inactivity.
Position
Integrated discharge
management
Charging
Bekijk gratis de handleiding van Hymer Exsis I (2025), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hymer |
| Model | Exsis I (2025) |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 25423 MB |
