Husqvarna-Viking Designer Topaz 25 Handleiding (88 Pagina's)

Handleiding

38

3 4

B

A

C

5

STITCH DENSITY (3)

If you have selcted a buttonhole the GraphicDisplay will show

the density setting instead of the stitch length setting. You will

now be able to change the density setting by pressing the +

and – buttons.

,I \RXSUHVVWKH$OWHUQDWH9LHZEXWWRQ$WKH

GraphicDisplay will show the density setting for satin stitches.

Use the + and –EXWWRQV%WRFKDQJHWKHVHWWLQJ

Note This is often used with specialty threads and when a less dense satin

stitch is desired.

NEEDLE POSITION (4)

If a straight stitch is selected the needle position is shown on

the GraphicDisplay instead of the stitch width. The + and –

EXWWRQV&DUHXVHGWRPRYHWKHQHHGOHWRWKHOHIWRUULJKWLQ

29 positions.

MIRROR SIDE TO SIDE (5)

3UHVVWKH0LUURU6LGHWR6LGHEXWWRQ&WRPLUURUWKHVHOHFWHG

stitch side to side. If the button is pressed when straight stitch

with left needle position is selected, the needle position is

FKDQJHGIURPOHIWWRULJKW,I WKHEXWWRQLVSUHVVHGLQ6HZ

Out Mode for stitch programs, the whole stitch program is

mirrored. The change is visible on the GraphicDisplay and an

LFRQLVVKRZQLQGLFDWLQJWKDW0LUURU6LGHWR6LGHLVDFWLYDWHG

Note: If a stitch cannot be mirrored a beep will be heard when pressing

the Mirror Side to Side button.

Stitch density –Stitch density +

Bekijk gratis de handleiding van Husqvarna-Viking Designer Topaz 25, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.