Hughes & Kettner GrandMeister 36 handleiding

Niet gecategoriseerd

Hughes & Kettner

72 pagina's

PDF beschikbaar

Handleiding

GrandMeister 36 – Manual 1.4

8.2 MIDI implementation chart / controller list

In addition to controlling all switching functions via sending MIDI program

changes, you can also change the parameters of every single editing

function of the amp in real time via sending MIDI control changes. The

following chart shows the editable functions and the corresponding

controller numbers:

Controller

number

Function

1 Modulation Intensity

4 Delay Time, 128 steps, 51 ms to 1360 ms

7Volume (soft)

9 Mute On-Off. On status remains active until the amp channel is changed,

the volume parameter is changed or the amp is re-started.

12 Mod-FX Type

20 Gain (soft)

21 Bass

22 Mid

23 Treble

24 Resonance

25 Presence

26 Modulation Speed (always for the active modulation effect)

27 Delay Feedback

28 Delay Volume

29 Reverb Volume

30 Power Soak Switching (5 sectors)

31 Channel Switching (4 sectors)

52 Mod-FX On-Off

53 Delay On-Off

54 Reverb On-Off

55 FX-Loop On-Off

56 Gain (hard)

57 Volume (hard)

63 Noise Gate On-Off

64 Boost On-Off

8.3 Factory Reset

A factory reset is a seldom-needed feature. Nonetheless, please read these

instructions carefully to ensure you don’t accidentally delete your presets.

You can perform a factory reset by doing the following:

Press "Store" and "FX Access" simultaneously while powering the amp

up by using the Power/On switch. Both buttons will flash three times to

indicate the successful factory reset.

Caution: Please note that this procedure is a last-resort option. It will

reset all settings, including the 128 MIDI-switchable presets (chapter 2)

and the basic MIDI configuration (chapter 8.1).

9 AES (EU version only)

Referred to Commission Regulation (EC) No. 1275/2008,

electrical and electronic devices need to be equipped

with an energy saving mechanism which automatically

switches the device off after not being used for a certain

period of time. On your GrandMeister 36, this mechanism is called AES.

It can be activated and deactivated with the mini switch right next to the

speaker jack.

Factory default is AES on; the mini switch is in the left position. In this

mode, the amp will automatically be switched off after a phase of silence

of about 90 minutes. The phase of silence is reset and starts again, as soon

as the amp receives an input signal (e.g. by playing a note). A quite gentle

signal is enough to trigger the re-start of the 90 minutes phase of silence

until the amp will switch off automatically. After automatically being shut

down by AES, the amp can be switched back on by flipping the Power/

On switch off and then on again.

Moving the mini switch to the right will deactivate AES, so it will not shut

down the amp.

Bekijk gratis de handleiding van Hughes & Kettner GrandMeister 36, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.