HP ProDesk 2 SFF G1i E handleiding
Handleiding
Je bekijkt pagina 37 van 124
Table 4-9 Heat sink with fan description and part number
Description Spare part number
Heat sink with fan P29815-001
IMPORTANT: The bond between the heat sink and the processor can be very tight.
If the computer will turn on, before removing the heat sink, turn on the computer until it warms the heat
sink. Warming the heat sink loosens the bond between the heat sink and the processor, thereby making
it easier to separate them.
Do not pull the processor out of the socket when you lift the heat sink, especially if you cannot warm
the heat sink before removal. Inadvertently removing the processor can damage the pins.
Before removing the heat sink with fan, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 19).
2. Remove the access panel (see Access panel on page 19).
3. Remove the fan duct (see Fan duct on page 22).
Remove the heat sink with fan:
1. Disconnect the fan cable from the system board connector (1).
2. Loosen the four captive screws (2) that secure the heat sink to the system board tray.
IMPORTANT: Remove heat sink retaining screws in diagonally opposite pairs (as in an X) to evenly
apply the downward forces on the processor. The pins on the socket are fragile, and any damage to
them could require replacing the system board.
3. Lift the heat sink (3) from the processor.
30
Chapter 4 Removal and replacement procedures
Bekijk gratis de handleiding van HP ProDesk 2 SFF G1i E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | HP |
| Model | ProDesk 2 SFF G1i E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 15941 MB |
