Hotone Verbera handleiding
Handleiding
Je bekijkt pagina 23 van 34
Clone Function
21
Verbera
→
Target Pedal
Use a TS (mono) cable to go from the Left Output of the Verbera to the
Input of the pedal you want to clone.
Target Pedal
→
Verbera
Now take the output of your reverb pedal and connect it to the Input of
the Verbera.
• For stereo pedals: Use a TRS-to-dual-TS splitter cable to send both Left
and Right outputs into the Verbera.
• For mono pedals: A regular TS cable is fine.
▶
Step 3: Set Up Your Reverb Pedal
To get the cleanest clone:
Set your pedal to 100% wet (only reverb, no dry signal).
If your pedal doesn’t have a full wet option, no worries — the Verbera will
still capture it, but it’ll include some dry tone too. Later on, you can tweak
the Attack setting on the Verbera to reduce that if needed.
And again:
1. turn off modulation or shimmer on the reverb pedal — the Verbera doesn’t clone those. You
can always add modulation later using the Verbera’s built-in Mod control.
2. The maximum reverb length that can be cloned: 20 seconds (mono) or 10 seconds (stereo).
Once the device loop is connected, click Start to begin cloning. Wait for
the progress bar to complete, then disconnect from the cloning device.
You can now choose to save or delete the cloned IR.
Bekijk gratis de handleiding van Hotone Verbera, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hotone |
| Model | Verbera |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5262 MB |