Holzmann EISA160-MINI handleiding
Handleiding
Je bekijkt pagina 23 van 35
SAFETY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at 23
EISA160MINI
• A damaged or tangled cable increases the risk of electric shock. Handle the cable with care.
Never use the cable to carry, pull or disconnect the power tool. Keep the cable away from
heat, oil, sharp edges or moving parts.
• Proper plugs and outlets reduce the risk of electric shock.
• Water entry into the machine increases the risk of electric shock. Do not expose the
machine to rain or moisture.
• The machine may only be used if the power supply is protected by a residual current circuit
breaker.
• Use the machine only when the ON-OFF switch is in good working order.
• Before connecting the machine always make sure that it is switches off.
12.6 Special safety instructions for this machine
• Only electrodes (rod electrode) suitable for the machine may be used.
• Never immerse the electrode (rod electrode) in liquids for cooling.
• Never touch the electrode (rod electrode) when the power source is switched on.
• Do not expose yourself or other persons without protection to electric arc or hot metal.
Spraying welding pearls may cause burns.
• Do not carry out welding or cutting work on sealed tanks, vessels or pipes unless these have
been prepared in accordance with the relevant national and international standards.
• Do not carry out welding on containers that are being or have been used to store gases,
propellants, mineral oils or similar products. Residues pose an explosive hazard.
• Workplaces shall be shielded in such a way that persons in the vicinity are protected.
• Keep your face away from welding fumes and gases.
• Ensure an adequate supply of fresh air. Otherwise, a welding helmet with an air supply
must be worn.
• Sparks and pieces of hot metal may also get into adjacent areas through small gaps or
openings. Take appropriate precautions to prevent any danger of injury or fire.
• A suitable, tested fire extinguisher must be available and ready for use.
• Make sure that you and others are protected with an adequately insulated, dry base or
cover for the earth or ground potential. This base or cover must extend over the entire area
between the body and the earth or ground potential.
• Do not wrap cables or leads around the body or parts of the body.
• Ensure that the earth clamp is firmly connected to the workpiece as close as possible to the
welding point. Make sure that the connection at the contact point is metallically bright!
12.7 Hazard Warnings
Despite the intended use, certain residual risks remain.
• Never touch the workpiece during or after welding
- risk of burns
• Slag can jump off cooling workpieces
- The specified protective equipment must therefore also be worn when reworking
workpieces and steps must be taken to ensure that other people are also adequately
protected.
• Risk of electric shock if incorrect electrical connections are used.
• Risk of tripping due to supply lines on the floor.
- Properly route supply lines and cables
Residual risks can be minimized if the "Safety instructions" and the "Intended use" as well as the
operating instructions are observed. Due to the design and construction of the machine,
hazardous situations may occur when handling the machines, which are identified in these
operating instructions as follows:
DANGER
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Bekijk gratis de handleiding van Holzmann EISA160-MINI, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Holzmann |
| Model | EISA160-MINI |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6917 MB |
