Hobart LXNR-2 handleiding
Handleiding
Je bekijkt pagina 30 van 32
– 30 –
Error
No.
Text On Screen Error Description Troubleshooting
085 Wash tank overtemp
tripped.
Wash tank overtemp has
been tripped.
Error cannot be cleared until overtemp has
been reset. Contact Hobart Service.
086 Booster overtemp tripped. Booster overtemp has been
tripped.
Error cannot be cleared until overtemp has
been reset. Contact Hobart Service.
087 -
perature not reached after
repeating cycle.
is less than the set point.
Press and hold the power button for
5 seconds to clear the error. The machine
will drain and power off. If the error persists,
contact Hobart Service.
088 Wash tank heater contactor
error. Contact service.
Wash tank heater remains
on while ignoring software
command to turn off.
protect the heater. This error is not user
serviceable. Turn circuit breaker supply off
and contact Hobart Service.
089 Booster heater contactor
error. Contact service.
Booster heater remains
on while ignoring software
command to turn off.
protect the heater. This error is not user
serviceable. Turn circuit breaker supply off
and contact Hobart Service.
090 Temperature not reached.
Drain and restart machine.
If necessary contact
service technician.
The wash temperature did
not reach the minimum set
point requirement within
time out period.
Press and hold the power button for
5 seconds to clear the error. The machine
will drain and power off. If the error persists,
contact Hobart Service.
SYMPTOM POSSIBLE CAUSE
No machine operation (no display).
1. Machine OFF - turn machine ON.
2. Blown fuse or tripped circuit breaker at power supply.
3. Cord not plugged in (corded models only).
No machine operation (with display).
1. Display: "DOOR OPEN" - open and close door. If problem
Dishes not clean.
1. Strainers clogged causing inadequate water supply to pump -
clean according to instructions. (See CLEANING.)
2. Obstruction in wash arm(s) or wash arms will not turn - clean
according to instructions. (See CLEANING.)
3. Wash and/or rinse arms will not turn - check that they spin
freely.
4. Detergent dispenser may be clogged.
5. Soil quantity - scrape dishes before cycle.
6. Improper rack loading. (See PREPARATION.)
7. Low water - check water supply.
8. Water temperature too low - note wash temperature on display
during WASH; should be above 120°F for chemical sanitizing
machines and above 150°F for high temperature machines.
9. Incoming water supply turned off.
Spotting of silverware, glasses or dishes.
1. Improperly loaded racks.
2. Water temperature too low.
3. Improper type or concentration of detergent - contact your
chemical representative.
4. Hard water - install a water softener; use a rinse agent.
This section outlines various symptoms and possible causes that may be encountered in the event of abnormal
machine operation. If symptoms persist after possible causes have been checked, service may be required.
Bekijk gratis de handleiding van Hobart LXNR-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hobart |
| Model | LXNR-2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4923 MB |
