Hobart LXNR-2 handleiding
Handleiding
Je bekijkt pagina 31 van 32
– 31 –
SYMPTOM POSSIBLE CAUSE
Chemicals not feeding.
1. Low on chemicals - check levels.
2. Air leak at feeder hose connections - check insertion of quick
3. Tubes kinked - check for smooth bends.
Food soils remain in dishwasher. Follow daily cleaning instructions. (See CLEANING.)
Appearance of rust in machine.
1. Ensure steel wool is not used to clean machine.
2. May be due to high iron content in water supply.
Unexpected results on dishes.
1. Etching - usually caused by any combination of high
temperatures, soft water, soft glass, or high alkaline washing
solutions.
2. Tarnishing - avoid washing silver, silver plates, and pewter in
chemical sanitizing machines.
3. Pitting - stainless steel may pit with lengthy contact of foods
containing salt, fruit juices, vinegar, etc. Wash immediately.
4. Black or gray marks - may have been rubbed with aluminum.
5. Brown stains - may be due to high iron content in water supply.
6. Chipping - improper loading or ware is too delicate.
7. Fading of china patterns - usually due to high water temperature
and strong detergent. Check that china is dishwasher
compatible.
8. Wooden ware damage - avoid washing in dishwasher.
9. Rust on cast iron - seasoning is lost in dishwasher. Avoid
washing in dishwasher.
10. Plastic ware distortion - high temperatures. Check plastic
ware's instructions.
Low temperature readings.
1. Low water supply temperature - make sure it meets the
recommended minimum temperature.
2. Rapid cycle use - if incoming water temperature is low and
to meet the demand.
3. Heavy ware load cools wash water - do not overload racks.
4. Booster heater or sump heater set low-contact your local
enough.
1. Low water pressure - check for clogged hose strainer; ensure
1. Machine not level. (see LEVELING.)
2. Fill solenoid valve leaking - power the dishwasher OFF; if water
Machine will not drain.
1. Drain pipes restricted - check dishwasher drain line for kinks;
ensure proper drain rate is allowed from plumbing.
2. Power machine OFF. Wait several seconds and then power
back ON. Repeat this procedure twice if necessary. If problem
Some water occasionally drips out
of rinse arms (high temperature
dishwashers only).
This is normal due to expansion of water being heated in the
booster tank.
Bekijk gratis de handleiding van Hobart LXNR-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hobart |
| Model | LXNR-2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4923 MB |
