HK Audio DSP Control handleiding
Handleiding
Je bekijkt pagina 7 van 17
- 7 -
Manual 1.2DSP CONTROL
• Deutsch • English
•
Speaker Panel
This panel affords you access to the input channel’s basic settings.
You can adjust all of the controls pictured here; all changes are
instantly applied to the SPEAKER window. We recommend using
the SPEAKER window to fine-tune settings. See page 7, SPEAKER
Window, for more on this.
Input Level
Adjust the input level with the fader or by entering a value in the
input box above it. It sweeps from –60 to 0 dB. Simply slide it to
"off" if you wish to switch the channel off.
Heads up: The level shown here is relative rather than absolute. It
depends on the level set on the speaker. In other words, 0
dB corresponds to whatever the GAIN knob setting on the speaker
happens to be at the time.
Mute
MUTE
Clicking the Mute button silences the input. The button lights up
red.
Invert
INVERT
The Invert button reverses the channel’s polarity. The button lights
up yellow.
• DSP OUT Panel
This panel affords you access to the DSP OUT channel’s basic
settings. You can adjust all of the controls pictured here; all
changes are instantly applied to the DSP OUT window. We
recommend using the DSP OUT window to fine-tune settings. See
page 8, DSP OUT Window, for more on this.
• Limiter Activity Panel
This panel shows you what the system’s limiters are doing.
It serves visual monitoring purposes only, so you cannot adjust its
settings. Go to the SPEAKER or DSP OUT windows to set limiter
parameters.
SPEAKER Window
The SPEAKER window lets you confi gure the selected speaker. These
settings only a ect the speaker’s response, and not the DSP OUT port.
See section 3.3 to learn more.
On the left is the same window selection panel found in the MAIN
window. The center panel provides signal-processing tools. On the right
is the same fader panel found in the MAIN window’s SPEAKER panel.
Equalizer
The equalizer features ten bands that you can confi gure individually.
Set the frequency (Freq), the quality factor that determines the fi lter’s
bandwidth (Q) and gain (Gain) by entering the values in the respective
input boxes. You can also adjust the frequency and gain by moving the
EQ points on the EQ display. All EQ bands may be switched on and o
individually.
The EQ 1 to EQ 10 buttons activate filters. The button lights up in
the color of the given frequency band.
Select the filter type in the Type drop-down menu:
Your options are:
• Bell, Notch, All Pass, Low Shelf, High Shelf, Band Pass, High Pass,
Low Pass
• The frequency (Freq) range sweeps from 20 to 20,000 Hz.
• The quality factor that determines the fi lter’s bandwidth (Q) can be
set in the range of 0.5 to 25.0.
• Gain adjusts from -12 to +12 dB.
Bekijk gratis de handleiding van HK Audio DSP Control, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | HK Audio |
| Model | DSP Control |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6688 MB |
