Hilti AG 600-20SE handleiding
Handleiding
Je bekijkt pagina 17 van 80
*2381081*
2381081 English 11
AG 60020SE
Ambient temperature for operation
−17 ℃ … 60 ℃
(1 ℉ … 140 ℉)
Storage temperature
−20 ℃ … 70 ℃
(−4 ℉ … 158 ℉)
5 Use of extension cords
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance’s supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate gauge
(cross section). The power tool may otherwise suffer a drop in performance and the extension cord may
overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
Information on recommended minimum conductor cross-sections and cable lengths is accessible via
a link, in the form of a QR code, at the end of this document.
6 Preparations at the workplace
CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Fitting the side handle
▶ Screw the side handle into one of the threaded bushings provided.
6.2 Setting speed stage
WARNING
Risk of injury due to change of speed stage when tool is under load. Loss of control over the product.
▶ Change the speed stage setting only when the product is either switched off or running under no load.
▶ Hold the product firmly by the grip while changing the speed stage setting with the product running
under no load.
The product has 6 speed stages; use the + and - buttons to select the speed stage you want to use.
You can select a speed stage before you switch on the product or change the speed stage while the product
is running.
The LEDs show the current speed stage.
Setting with product switched off
▶ Press the + button or the - button.
▶ The indicator for speed stages is activated and shows the stage currently selected.
▶ Use the + / - buttons to select the speed stage.
▶ The indicator for the speed stages is deactivated after 15 seconds.
▶ The speed stage you selected is saved in memory.
Bekijk gratis de handleiding van Hilti AG 600-20SE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hilti |
| Model | AG 600-20SE |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8376 MB |
