Hilti AG 600-20SE handleiding
Handleiding
Je bekijkt pagina 18 van 80
12 English 2381081
*2381081*
Setting with product switched on
▶ Use the + / - buttons to select the speed stage.
▶ The speed stage you select is set and remains saved in memory when you switch the product off.
6.3 Guard
▶ Observe the instructions for fitting the applicable guard.
6.3.1 Installing the guard 6
The guard is keyed to ensure that only guards of a type suitable for use with the product can be
installed. The keyed locating lug also prevents the guard from coming into contact with the tool.
1. Fit the guard on to the arbor collar so that the two triangular marks on the guard and on the product are
in alignment.
2. Press the guard on to the drive spindle collar.
3. Press the guard release button and turn the guard until it engages in the desired position.
▶ The guard release button jumps back.
6.3.2 Adjusting the guard 7
▶ Press the guard release button and turn the guard until it engages in the desired position.
6.3.3 Removing the guard
1. Press the guard release button and turn the guard until the triangular marks on the guard and on the
product are in alignment.
2. Lift off the guard.
6.4 Fitting or removing the front cover 8
1. Position the front cover with the closed side on the standard guard and push it on until it engages.
2. To remove it, release the catch for the front cover and then lift the front cover away from the standard
guard.
6.5 Installing or removing wheels
CAUTION
Risk of injury. The accessory tool may be hot.
▶ Wear protective gloves when changing the accessory tool.
Diamond wheels must be replaced when their cutting or grinding performance drops significantly. This
generally is the case when the diamond segments reach a height of less than 2 mm (1/16").
Other wheels must be replaced when their cutting performance drops significantly or other parts of
the angle grinder (not the wheel) come into contact with the material you are working on.
Abrasive wheels must be replaced when their expiry date has been reached.
6.5.1 Fitting the grinding wheel 9
WARNING
Risk of injury. The accessory tool may work loose due to the braking effect of the motor.
▶ Wait until the accessory tool has come to a standstill before touching or gripping the accessory tool or
the clamping nut.
▶ Secure the accessory tool by tightening the clamping flange and clamping nut firmly so that no parts
work loose from the spindle due to the braking effect of the motor.
1. Check that the O-ring is in place in the clamping flange and that it is undamaged.
Result
The O-ring is damaged.
There is no O-ring in the clamping flange.
▶ Fit a new clamping flange with O-ring.
2. Fit the clamping flange on to the drive spindle.
Bekijk gratis de handleiding van Hilti AG 600-20SE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hilti |
| Model | AG 600-20SE |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8376 MB |
