Handleiding
Je bekijkt pagina 6 van 43
www.heinner.com
5
Prepare the installation:
• Ensure the power has been turned off before beginning this installation. Plug must be assembled in
places that are easy to drag and insert.
• To install this hood, you will require two assistants. You will need the following tools and material to
complete this installation.
• Tools you will need: Drill appropriate to your wall, Crosshead screwdriver, Tape measure, Hand saw or
Jigsaw.
• Installation work and electrical wiring must be done by qualified person(s) in accordance with all
applicable codes and standards, including fire rated construction.
• Do not discharge the exhaust air into the flu from other appliances burning gas or other fuels.
• Regulations concerning the discharge of air have to be fulfilled.
• The cooker hood must be placed at a minimum distance of 65cm above the cooking surface of a hob.
• The cooker hood must be placed at a maximum distance of 75cm above the cooking surface of a hob.
Cupboard mounting installation
• Drill a 130mm diameter and four 3.5mm diameter holes as below picture.
• ATTENTION: If your cooker hood works at circulating-air mode, it is not necessary to drill a 130mm
diameter hole.
• Use the 4 screws to fix the cooker hood to a kitchen cupboard. Check that your fixings are correctly
located, by temporarily fitting the cooker hood. If correct, fit the unit into position. Tighten the screws if
necessary.
Wall mounting installation
• To mount on the wall, drill two10mm diameter holes 538mm with the vent hole on the top of the cooker
hood in the middle as below picture. Make sure the hood is aligned directly over the hob.
• Insert two plastics wall plugs(supplied) into the holes.
• Insert two screws into the upper two plastic wall plugs and tighten them leaving 3mm protruding from
the wall.
• Mount the cooker hood onto the two screws and mark the bottom two screw positions.
• Remove the hood and drill the bottom two screw holes and insert the plastic wall plugs.
• Mount the hood on the top screws, Insert the bottom screws and fully tighten all the screws.
Bekijk gratis de handleiding van Heinner CH-MD200WH, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Heinner |
| Model | CH-MD200WH |
| Categorie | Afzuigkap |
| Taal | Nederlands |
| Grootte | 9515 MB |
