Hazet 9513-2100 handleiding
Handleiding
Je bekijkt pagina 18 van 200
18
[
+49 (0) 21 91 / 7 92-0 •
^
hazet.de •
]
info@hazet.de
18
9513-2100
Reverse Rotation:
Indicator light on control
panel
Working
Mode
Maximum IPM
(Impacts per minute)
Application
1 1000
Fine-tuned loosening of
small bolts and nuts.
2 2000
Moderate loosening
torque.
3 2350
Maximum loosening
torque.
A /
Loosening with automatic
stop.
ON; OFF
WARNING!
Do not change the working mode while the
tool is running.
Sudden change of torque may
cause the loss of control causing possible
injury or damage to the tool or workpiece.
NOTE
The variety of wood density and metal
material may affect the final outcome. The
user should select appropriate mode based
on the application.
NOTE
The LED indicator will turn off approximately
1min after the trigger switch is released.
NOTE
When the tool is next turned on, the working
mode will revert to the previous setting.
Switching on the power tool (see
figure K)
■
To switch the power tool on:
Press the trigger switch (2).
The variable-speed trigger switch (2) delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
■
To switch the power tool off:
Release the trigger switch(2).
LED light (see figure L& M)
Your tool is equipped with two LED work
lights (4&5) with adjustable brightness. The
two LED work lights(4&5) are on and off at
the same time and also adjust the brightness
synchronously.
To adjust the work light brightness, Press the
“drive-control button”
(J-3) and “M”
button(J-1) simultaneously for 2 seconds until
the four indicator lights (J-2) start flashing at
the same time, indicating that the tool has
entered the work light brightness adjustment
mode.
In the work light brightness adjustment mode,
each time you press the trigger switch(2),
the brightness will change to the next level
and will a cycle among the following six
brightness levels.
1 23456
Light off Lowest
Highest
The next time the tool is turned on and the
memory function will remember and revert to
the last work light brightness level.
The light will turn off automatically
approximately 10 seconds after the trigger
switch is released.
Tighten and loosen nuts and
bolts (see figure N)
To tighten nuts and bolts
Use either mode 1, 2, 3 or “M” mode to
tighten nuts and bolts depending on the
Bekijk gratis de handleiding van Hazet 9513-2100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hazet |
| Model | 9513-2100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 28478 MB |
