Handleiding
Je bekijkt pagina 51 van 73
Page EN-14 Installing, connecting and start-up
(3)
(1)
(4)
(2)
(5)
(6)
Preparing and inserting the hob
NOTICE
Risk of damage to property!
Improper use may result in damage to the
equipment.
n
Do not place the hob on the glass-
ceramic edge!
n
Make sure there is adequate ventila-
tion. Do not block the vents.
1. Remove the hob from the packaging.
2. Remove all protective films and adhes-
ive tapes.
3. Turn the hob over and place it with the
glass side down on a soft surface.
5 cm min
5 cm min
5 cm min
4. Make sure that there is a recess in the
work surface corresponding to the di-
mensions shown in the illustration. The
space above the hob should be at least
76 cm.
(28)
5. Attach the retaining clips to the hob us-
ing the screws (28).
6. Place the hob in the recess. Check that
the seal is properly and securely
seated.
Connecting the oven
Depending on the installation recess, the
oven must be connected before or after in-
stallation.
– For the electrical connection of the over,
you need a properly installed protective
contact socket with its own sufficient
fuse (380-420 V 3 N~/50 Hz).
– Connect the mains cord according to the
connection diagrams.
Inserting the oven
WARNING
Risk of electric shock!
Incorrect installation/dismantling can
cause electric shock.
n
Before installing/dismantling the appli-
ance, check that the socket to which
the appliance is connected is switched
off.
Bekijk gratis de handleiding van Hanseatic HBCO707A, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Hanseatic |
| Model | HBCO707A |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 8072 MB |
